OpenWrt – Rev 1

Subversion Repositories:
Rev:
/dts-v1/;

#include "ar9.dtsi"

#include <dt-bindings/input/input.h>

/ {
        compatible = "avm,fritz7320", "lantiq,xway", "lantiq,ar9";
        model = "AVM FRITZ!Box 7320";

        chosen {
                bootargs = "console=ttyLTQ0,115200";
        };

        aliases {
                led-boot = &power;
                led-failsafe = &power;
                led-running = &power;
                led-upgrade = &power;

                led-internet = &info_green;
                led-dsl = &power;
                led-wifi = &wlan;
        };

        memory@0 {
                reg = <0x0 0x4000000>;
        };

        gpio-keys-polled {
                compatible = "gpio-keys-polled";
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <100>;

                rfkill {
                        label = "rfkill";
                        gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
                        linux,code = <KEY_RFKILL>;
                };
                dect {
                        label = "dect";
                        gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
                        linux,code = <KEY_PHONE>;
                };
        };

        gpio-leds {
                compatible = "gpio-leds";
                power: power {
                        label = "fritz7320:green:power";
                        gpios = <&gpio 44 GPIO_ACTIVE_LOW>;
                        default-state = "keep";
                };
                voice {
                        label = "fritz7320:green:fon";
                        gpios = <&gpio 47 GPIO_ACTIVE_LOW>;
                };
                dect {
                        label = "fritz7320:green:dect";
                        gpios = <&gpio 38 GPIO_ACTIVE_LOW>;
                };
                wlan: wlan {
                        label = "fritz7320:green:wlan";
                        gpios = <&gpio 37 GPIO_ACTIVE_LOW>;
                };
                info_green: info_green {
                        label = "fritz7320:green:info";
                        gpios = <&gpio 35 GPIO_ACTIVE_LOW>;
                };
                info_red {
                        label = "fritz7320:red:info";
                        gpios = <&gpio 45 GPIO_ACTIVE_LOW>;
                };
        };
};

&gpio {
        pinctrl-names = "default";
        pinctrl-0 = <&state_default>;

        state_default: pinmux {
                pci {
                        lantiq,groups = "gnt1", "req1", "req2", "req3", "req4", "gnt2", "gnt3", "gnt4";
                        lantiq,function = "pci";
                };
                pci-in {
                        lantiq,groups = "req1", "req2", "req3", "req4";
                        lantiq,output = <0>;
                        lantiq,open-drain = <1>;
                        lantiq,pull = <2>;
                };
                pci-out {
                        lantiq,groups = "gnt1", "gnt2", "gnt3", "gnt4";
                        lantiq,output = <1>;
                        lantiq,pull = <0>;
                };
        };
};

&gsw {
        phy-mode = "mii";
        mtd-mac-address = <&ath9k_cal 0xa91>;
        mtd-mac-address-increment = <(-2)>;
};

&localbus {
        nor@0 {
                compatible = "lantiq,nor";
                bank-width = <2>;
                reg = <0 0x0 0x1000000>;
                #address-cells = <1>;
                #size-cells = <1>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        ath9k_cal: partition@0 {
                                label = "urlader";
                                reg = <0x00000 0x20000>;
                                read-only;
                        };

                        partition@20000 {
                                label = "firmware";
                                reg = <0x20000 0xf60000>;
                        };

                        partition@f80000 {
                                label = "tffs (1)";
                                reg = <0xf80000 0x40000>;
                                read-only;
                        };

                        partition@fc0000 {
                                label = "tffs (2)";
                                reg = <0xfc0000 0x40000>;
                                read-only;
                        };
                };
        };
};

&pci0 {
        status = "okay";
        req-mask = <0xf>;
        gpio-reset = <&gpio 21 GPIO_ACTIVE_HIGH>;

        wifi@0,0 {
                compatible = "pci0,0";
                reg = <0x7000 0 0 0 0>;
                qca,no-eeprom; /* load from ath9k-eeprom-pci-0000:00:0e.0.bin */
        };
};

&usb_phy0 {
        status = "okay";
};

&usb_phy1 {
        status = "okay";
};

&usb0 {
        status = "okay";
};

&usb1 {
        status = "okay";
};