OpenWrt – Rev 1

?pathlinks?

Blame – Last modification – View Log – Download

--- a/arch/arm/boot/dts/Makefile
+++ b/arch/arm/boot/dts/Makefile
@@ -237,6 +237,7 @@ dtb-$(CONFIG_MACH_KIRKWOOD) += \
        kirkwood-ds411.dtb \
        kirkwood-ds411j.dtb \
        kirkwood-ds411slim.dtb \
+       kirkwood-goflexhome.dtb \
        kirkwood-goflexnet.dtb \
        kirkwood-guruplug-server-plus.dtb \
        kirkwood-ib62x0.dtb \
--- /dev/null
+++ b/arch/arm/boot/dts/kirkwood-goflexhome.dts
@@ -0,0 +1,117 @@
+/dts-v1/;
+
+#include "kirkwood.dtsi"
+#include "kirkwood-6281.dtsi"
+
+/ {
+       model = "Seagate GoFlex Home";
+       compatible = "seagate,goflexhome", "marvell,kirkwood-88f6281", "marvell,kirkwood";
+
+       memory {
+               device_type = "memory";
+               reg = <0x00000000 0x8000000>;
+       };
+
+       chosen {
+               bootargs = "console=ttyS0,115200n8 earlyprintk root=/dev/sda1 rootdelay=10";
+               stdout-path = &uart0;
+       };
+
+       ocp@f1000000 {
+               pinctrl: pin-controller@10000 {
+                       pmx_usb_power_enable: pmx-usb-power-enable {
+                               marvell,pins = "mpp29";
+                               marvell,function = "gpio";
+                       };
+                       pmx_led_white: pmx-led-white {
+                               marvell,pins = "mpp40";
+                               marvell,function = "gpio";
+                       };
+                       pmx_led_green: pmx-led_green {
+                               marvell,pins = "mpp46";
+                               marvell,function = "gpio";
+                       };
+                       pmx_led_orange: pmx-led-orange {
+                               marvell,pins = "mpp47";
+                               marvell,function = "gpio";
+                       };
+               };
+               serial@12000 {
+                       status = "ok";
+               };
+
+               sata@80000 {
+                       status = "okay";
+                       nr-ports = <2>;
+               };
+
+       };
+       gpio-leds {
+               compatible = "gpio-leds";
+
+               health {
+                       label = "status:green:health";
+                       gpios = <&gpio1 14 GPIO_ACTIVE_LOW>;
+                       linux,default-trigger = "default-on";
+               };
+               fault {
+                       label = "status:orange:fault";
+                       gpios = <&gpio1 15 GPIO_ACTIVE_LOW>;
+               };
+               misc {
+                       label = "status:white:misc";
+                       gpios = <&gpio1 8 GPIO_ACTIVE_LOW>;
+                       linux,default-trigger = "disk-activity";
+               };
+       };
+       regulators {
+               compatible = "simple-bus";
+               #address-cells = <1>;
+               #size-cells = <0>;
+               pinctrl-0 = <&pmx_usb_power_enable>;
+               pinctrl-names = "default";
+
+               usb_power: regulator@1 {
+                       compatible = "regulator-fixed";
+                       reg = <1>;
+                       regulator-name = "USB Power";
+                       regulator-min-microvolt = <5000000>;
+                       regulator-max-microvolt = <5000000>;
+                       enable-active-high;
+                       regulator-always-on;
+                       regulator-boot-on;
+                       gpio = <&gpio0 29 GPIO_ACTIVE_HIGH>;
+               };
+       };
+};
+
+&nand {
+       chip-delay = <40>;
+       status = "okay";
+
+       partition@0 {
+               label = "u-boot";
+               reg = <0x0000000 0x100000>;
+               read-only;
+       };
+
+       partition@100000 {
+               label = "ubi";
+               reg = <0x100000 0x0ff00000>;
+       };
+};
+
+&mdio {
+       status = "okay";
+
+       ethphy0: ethernet-phy@0 {
+               reg = <0>;
+       };
+};
+
+&eth0 {
+       status = "okay";
+       ethernet0-port@0 {
+               phy-handle = <&ethphy0>;
+       };
+};

---

Generated by GNU Enscript 1.6.5.90.