OpenWrt – Rev 1

Subversion Repositories:
Rev:
#!/bin/sh /etc/rc.common
#
# This script sets auto_recovery to "yes" and resets the boot counter to 0.
# As a golden rule, this should be the latest script to run at boot. For a
# developer snapshot, it is fine to set auto_recovery here. But for a stable
# release, this script must in fact turn off auto_recovery.
#
# Why? Because the custom sysupgrade script for the device will turn on
# auto_recovery to "yes". And it's the job of this script to set the
# boot boot_count to 0 and then disable auto_recovery, as that condition
# means that the stable release went well.
#
# I have to repeat: this script should be changed for stable releases.

START=99
boot() {
        . /lib/functions.sh

        case $(board_name) in
                linksys,ea6350v3)
                        # make sure auto_recovery in uboot is always on
                        IS_AUTO_RECOVERY="$(fw_printenv -n auto_recovery)"
                        if [ "$IS_AUTO_RECOVERY" != "yes" ] ; then
                                fw_setenv auto_recovery yes
                                echo "Linksys EA6350v3: fw_setenv: auto_recovery has been set to yes"
                        fi
                        # reset the boot counter
                        fw_setenv boot_count 0
                        mtd resetbc s_env
                        echo "Linksys EA6350v3: boot counter has been reset"
                        echo "Linksys EA6350v3: boot_part=$(fw_printenv -n boot_part)"
                        ;;
        esac
}