OpenWrt – Rev 1
?pathlinks?
/*
* This is a part of mm/cache-v7.S with extracted entry flushing D-cache. We
* need it for Broadcom devices with broken bootloader leaving cache enabled.
*
* Copyright (C) 2001 Deep Blue Solutions Ltd.
* Copyright (C) 2005 ARM Ltd.
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/linkage.h>
#include <linux/init.h>
__INIT
/*
* v7_flush_dcache_all()
*
* Flush the whole D-cache.
*
* Corrupted registers: r0-r7, r9-r11 (r6 only in Thumb mode)
*
* - mm - mm_struct describing address space
*/
ENTRY(v7_flush_dcache_all)
dmb @ ensure ordering with previous memory accesses
mrc p15, 1, r0, c0, c0, 1 @ read clidr
mov r3, r0, lsr #23 @ move LoC into position
ands r3, r3, #7 << 1 @ extract LoC*2 from clidr
beq finished @ if loc is 0, then no need to clean
start_flush_levels:
mov r10, #0 @ start clean at cache level 0
flush_levels:
add r2, r10, r10, lsr #1 @ work out 3x current cache level
mov r1, r0, lsr r2 @ extract cache type bits from clidr
and r1, r1, #7 @ mask of the bits for current cache only
cmp r1, #2 @ see what cache we have at this level
blt skip @ skip if no cache, or just i-cache
#ifdef CONFIG_PREEMPT
save_and_disable_irqs_notrace r9 @ make cssr&csidr read atomic
#endif
mcr p15, 2, r10, c0, c0, 0 @ select current cache level in cssr
isb @ isb to sych the new cssr&csidr
mrc p15, 1, r1, c0, c0, 0 @ read the new csidr
#ifdef CONFIG_PREEMPT
restore_irqs_notrace r9
#endif
and r2, r1, #7 @ extract the length of the cache lines
add r2, r2, #4 @ add 4 (line length offset)
movw r4, #0x3ff
ands r4, r4, r1, lsr #3 @ find maximum number on the way size
clz r5, r4 @ find bit position of way size increment
movw r7, #0x7fff
ands r7, r7, r1, lsr #13 @ extract max number of the index size
loop1:
mov r9, r7 @ create working copy of max index
loop2:
ARM( orr r11, r10, r4, lsl r5 ) @ factor way and cache number into r11
THUMB( lsl r6, r4, r5 )
THUMB( orr r11, r10, r6 ) @ factor way and cache number into r11
ARM( orr r11, r11, r9, lsl r2 ) @ factor index number into r11
THUMB( lsl r6, r9, r2 )
THUMB( orr r11, r11, r6 ) @ factor index number into r11
mcr p15, 0, r11, c7, c14, 2 @ clean & invalidate by set/way
subs r9, r9, #1 @ decrement the index
bge loop2
subs r4, r4, #1 @ decrement the way
bge loop1
skip:
add r10, r10, #2 @ increment cache number
cmp r3, r10
bgt flush_levels
finished:
mov r10, #0 @ swith back to cache level 0
mcr p15, 2, r10, c0, c0, 0 @ select current cache level in cssr
dsb st
isb
ret lr
ENDPROC(v7_flush_dcache_all)