OpenWrt – Rev 1

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "qca9557.dtsi"

/ {
        compatible = "ocedo,koala", "qca,qca9557";
        model = "OCEDO Koala";

        chosen {
                bootargs = "console=ttyS0,115200n8";
        };

        aliases {
                led-boot = &system;
                led-failsafe = &system;
                led-running = &system;
                led-upgrade = &system;
        };

        leds {
                compatible = "gpio-leds";

                power {
                        label = "koala:green:power";
                        gpios = <&gpio 22 GPIO_ACTIVE_LOW>;
                        default-state = "on";
                };

                wifi2 {
                        label = "koala:yellow:wlan2";
                        gpios = <&gpio 23 GPIO_ACTIVE_LOW>;
                        linux,default-trigger = "phy1tpt";
                };

                wifi5 {
                        label = "koala:red:wlan58";
                        gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
                        linux,default-trigger = "phy0tpt";
                };

                system: system {
                        label = "koala:blue:sys";
                        gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
                };
        };

        keys {
                compatible = "gpio-keys-polled";
                poll-interval = <100>;

                reset {
                        label = "reset";
                        linux,code = <KEY_RESTART>;
                        gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
                };
        };
};

&pcie0 {
        status = "okay";
};

&uart {
        status = "okay";
};

&pll {
        clocks = <&extosc>;
};

&spi {
        status = "okay";
        num-cs = <1>;

        flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <25000000>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        uboot: partition@0 {
                                label = "u-boot";
                                reg = <0x000000 0x040000>;
                                read-only;
                        };

                        partition@40000 {
                                label = "u-boot-env";
                                reg = <0x040000 0x010000>;
                        };

                        partition@50000 {
                                compatible = "denx,uimage";
                                label = "firmware";
                                reg = <0x050000 0x740000>;
                        };

                        partition@790000 {
                                label = "vendor";
                                reg = <0x790000 0x740000>;
                                read-only;
                        };

                        partition@ed0000 {
                                label = "data";
                                reg = <0xed0000 0x110000>;
                                read-only;
                        };

                        partition@fe0000 {
                                label = "id";
                                reg = <0xfe0000 0x010000>;
                                read-only;
                        };

                        art: partition@ff0000 {
                                label = "art";
                                reg = <0xff0000 0x010000>;
                                read-only;
                        };
                };
        };
};

&wmac {
        status = "okay";

        mtd-cal-data = <&art 0x1000>;
        mtd-mac-address = <&art 0x06>;
};

&mdio0 {
        status = "okay";

        phy5: ethernet-phy@5 {
                reg = <5>;
                phy-mode = "rgmii-rxid";

                at803x-disable-smarteee;
        };
};

&eth0 {
        status = "okay";

        mtd-mac-address = <&art 0x00>;

        phy-handle = <&phy5>;
        phy-mode = "rgmii-rxid";

        pll-data = <0x8e000000 0x80000101 0x80001313>;
};