OpenWrt – Rev 1

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "qca953x.dtsi"

/ {
        chosen {
                bootargs = "console=ttyS0,115200n8";
        };

        aliases {
                led-boot = &led_system;
                led-failsafe = &led_system;
                led-running = &led_system;
                led-upgrade = &led_system;
        };

        gpio_leds: leds {
                compatible = "gpio-leds";

                led_system: system {
                        label = "tp-link:blue:system";
                        gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
                };
        };

        keys {
                compatible = "gpio-keys";

                reset {
                        label = "Reset button";
                        linux,code = <KEY_RESTART>;
                        gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
                        debounce-interval = <60>;
                };

                switch_b0 {
                        label = "switch_b0";
                        linux,input-type = <EV_SW>;
                        linux,code = <BTN_0>;
                        gpios = <&gpio 1 GPIO_ACTIVE_HIGH>;
                        debounce-interval = <60>;
                };

                switch_b1 {
                        label = "switch_b1";
                        linux,input-type = <EV_SW>;
                        linux,code = <BTN_1>;
                        gpios = <&gpio 0 GPIO_ACTIVE_HIGH>;
                        debounce-interval = <60>;
                };
        };
};

&uart {
        status = "okay";
};

&spi {
        status = "okay";
        num-cs = <1>;

        flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <25000000>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        uboot:  partition@0 {
                                label = "u-boot";
                                reg = <0x000000 0x020000>;
                                read-only;
                        };

                        partition@20000 {
                                compatible = "tplink,firmware";
                                label = "firmware";
                                reg = <0x020000 0x7d0000>;
                        };

                        art: partition@7f0000 {
                                label = "art";
                                reg = <0x7f0000 0x010000>;
                                read-only;
                        };
                };
        };
};

&eth1 {
        mtd-mac-address = <&uboot 0x1fc00>;
};

&eth0 {
        status = "okay";
        phy-handle = <&swphy4>;

        mtd-mac-address = <&uboot 0x1fc00>;
        mtd-mac-address-increment = <1>;
};

&wmac {
        status = "okay";
        mtd-cal-data = <&art 0x1000>;
        mtd-mac-address = <&uboot 0x1fc00>;
};