OpenWrt – Rev 1
?pathlinks?
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
#include <dt-bindings/clock/ath79-clk.h>
#include "ath79.dtsi"
/ {
compatible = "qca,qca9530";
#address-cells = <1>;
#size-cells = <1>;
chosen {
bootargs = "console=ttyS0,115200n8";
};
cpus {
#address-cells = <1>;
#size-cells = <0>;
cpu@0 {
device_type = "cpu";
compatible = "mips,mips24Kc";
clocks = <&pll ATH79_CLK_CPU>;
reg = <0>;
};
};
extosc: ref {
compatible = "fixed-clock";
#clock-cells = <0>;
clock-output-names = "ref";
clock-frequency = <25000000>;
};
ahb {
apb {
ddr_ctrl: memory-controller@18000000 {
compatible = "qca,ar9530-ddr-controller",
"qca,ar7240-ddr-controller";
reg = <0x18000000 0x128>;
#qca,ddr-wb-channel-cells = <1>;
};
uart: uart@18020000 {
compatible = "ns16550a";
reg = <0x18020000 0x20>;
interrupts = <3>;
clocks = <&pll ATH79_CLK_REF>;
clock-names = "uart";
reg-io-width = <4>;
reg-shift = <2>;
no-loopback-test;
status = "disabled";
};
usb_phy: usb-phy@18030000 {
compatible = "qca,ar7200-usb-phy";
reg = <0x18030000 0x100>;
#phy-cells = <0>;
reset-names = "usb-phy", "usb-suspend-override";
resets = <&rst 4>, <&rst 3>;
status = "disabled";
};
gpio: gpio@18040000 {
compatible = "qca,ar9530-gpio",
"qca,ar9340-gpio";
reg = <0x18040000 0x28>;
interrupts = <2>;
ngpios = <20>;
gpio-controller;
#gpio-cells = <2>;
interrupt-controller;
#interrupt-cells = <2>;
};
pinmux: pinmux@1804002c {
compatible = "pinctrl-single";
reg = <0x1804002c 0x48>;
#size-cells = <0>;
pinctrl-single,bit-per-mux;
pinctrl-single,register-width = <32>;
pinctrl-single,function-mask = <0x1>;
#pinctrl-cells = <2>;
jtag_disable_pins: pinmux_jtag_disable_pins {
pinctrl-single,bits = <0x40 0x2 0x2>;
};
};
pll: pll-controller@18050000 {
compatible = "qca,qca9530-pll", "syscon";
reg = <0x18050000 0x48>;
#clock-cells = <1>;
clock-output-names = "cpu", "ddr", "ahb";
clocks = <&extosc>;
};
wdt: wdt@18060008 {
compatible = "qca,qca9530-wdt", "qca,ar7130-wdt";
reg = <0x18060008 0x8>;
interrupts = <4>;
clocks = <&pll ATH79_CLK_AHB>;
clock-names = "wdt";
};
rst: reset-controller@1806001c {
compatible = "qca,qca9530-reset",
"qca,ar7100-reset";
reg = <0x1806001c 0xac>;
#reset-cells = <1>;
intc2: interrupt-controller {
compatible = "qca,ar9340-intc";
interrupt-parent = <&cpuintc>;
interrupts = <2>;
interrupt-controller;
#interrupt-cells = <1>;
qca,int-status-addr = <0xac>;
qca,pending-bits = <0xf>, /* wmac */
<0x1f0>; /* pcie rc1 */
qca,ddr-wb-channel-interrupts = <0>, <1>;
qca,ddr-wb-channels = <&ddr_ctrl 4>, <&ddr_ctrl 3>;
};
};
pcie0: pcie-controller@180c0000 {
compatible = "qcom,ar7240-pci";
#address-cells = <3>;
#size-cells = <2>;
bus-range = <0x0 0x0>;
reg = <0x180c0000 0x1000>, /* CRP */
<0x180f0000 0x100>, /* CTRL */
<0x14000000 0x1000>; /* CFG */
reg-names = "crp_base", "ctrl_base", "cfg_base";
ranges = <0x2000000 0 0x10000000 0x10000000 0 0x04000000 /* pci memory */
0x1000000 0 0x00000000 0x0000000 0 0x000001>; /* io space */
interrupt-parent = <&intc2>;
interrupts = <1>;
interrupt-controller;
#interrupt-cells = <1>;
interrupt-map-mask = <0 0 0 1>;
interrupt-map = <0 0 0 0 &pcie0 0>;
status = "disabled";
};
gmac: gmac@18070000 {
compatible = "qca,ar9330-gmac";
reg = <0x18070000 0x4>;
};
wmac: wmac@18100000 {
compatible = "qca,qca9530-wmac";
reg = <0x18100000 0x20000>;
interrupt-parent = <&intc2>;
interrupts = <0>;
status = "disabled";
};
};
usb0: usb@1b000000 {
compatible = "generic-ehci";
reg = <0x1b000000 0x1000>;
interrupts = <3>;
resets = <&rst 5>;
reset-names = "usb-host";
dr_mode = "host";
has-transaction-translator;
caps-offset = <0x100>;
phy-names = "usb-phy";
phys = <&usb_phy>;
status = "disabled";
};
spi: spi@1f000000 {
compatible = "qca,ar9530-spi", "qca,ar7100-spi";
reg = <0x1f000000 0x10>;
clocks = <&pll ATH79_CLK_AHB>;
clock-names = "ahb";
status = "disabled";
#address-cells = <1>;
#size-cells = <0>;
};
};
};
&cpuintc {
qca,ddr-wb-channel-interrupts = <3>, <4>, <5>;
qca,ddr-wb-channels = <&ddr_ctrl 2>, <&ddr_ctrl 0>,
<&ddr_ctrl 1>;
};
ð0 {
compatible = "qca,qca9530-eth", "syscon";
pll-data = <0x82000101 0x80000101 0x80001313>;
reg = <0x19000000 0x200
0x18070000 0x4>;
pll-reg = <0x4 0x2c 17>;
pll-handle = <&pll>;
reset-names = "mac";
resets = <&rst 9>;
phy-mode = "mii";
};
&mdio1 {
status = "okay";
resets = <&rst 23>;
reset-names = "mdio";
builtin-switch;
builtin_switch: switch0@1f {
compatible = "qca,ar8229-builtin";
reg = <0x1f>;
resets = <&rst 8>;
reset-names = "switch";
phy-mode = "gmii";
phy4-mii-enable;
mdio-bus {
#address-cells = <1>;
#size-cells = <0>;
swphy0: ethernet-phy@0 {
reg = <0>;
phy-mode = "mii";
};
swphy4: ethernet-phy@4 {
reg = <4>;
phy-mode = "mii";
};
};
};
};
ð1 {
status = "okay";
compatible = "qca,qca9530-eth", "syscon", "simple-mfd";
resets = <&rst 13>;
reset-names = "mac";
phy-mode = "gmii";
fixed-link {
speed = <1000>;
full-duplex;
};
};