OpenWrt – Rev 1

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "qca953x.dtsi"

/ {
        compatible = "engenius,ews511ap", "qca,qca9531";
        model = "EnGenius EWS511AP";

        keys {
                compatible = "gpio-keys-polled";

                poll-interval = <20>;
                pinctrl-names = "default";
                pinctrl-0 = <&jtag_disable_pins>;

                reset {
                        label = "reset";
                        linux,code = <KEY_RESTART>;
                        gpios = <&gpio 1 GPIO_ACTIVE_LOW>;
                };
        };

        aliases {
                led-boot = &power_led;
                led-failsafe = &power_led;
                led-running = &power_led;
                led-upgrade = &power_led;
        };

        leds {
                compatible = "gpio-leds";

                power_led: power {
                        label = "ews511ap:amber:power";
                        gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
                        default-state = "on";
                };

                lan1 {
                        label = "ews511ap:blue:lan1";
                        gpios = <&gpio 4 GPIO_ACTIVE_LOW>;
                };

                lan2 {
                        label = "ews511ap:blue:lan2";
                        gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
                };

                wlan2g {
                        label = "ews511ap:green:wlan2g";
                        gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
                        linux,default-trigger = "phy0tpt";
                };

                wlan5g {
                        label = "ews511ap:green:wlan5g";
                        gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
                        linux,default-trigger = "phy1tpt";
                };
        };

        watchdog {
                compatible = "linux,wdt-gpio";

                gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
                hw_algo = "toggle";
                /* hw_margin_ms is actually 300s but driver limits it to 60s */
                hw_margin_ms = <60000>;
                always-running;
        };
};

&wdt {
        status = "okay";
};

&rst {
        status = "okay";
};

&pcie0 {
        status = "okay";
};

&uart {
        status = "okay";
};

&spi {
        status = "okay";
        num-cs = <0>;

        flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <25000000>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        partition@0 {
                                label = "u-boot";
                                reg = <0x000000 0x040000>;
                                read-only;
                        };

                        ubootenv: partition@40000 {
                                label = "u-boot-env";
                                reg = <0x040000 0x010000>;
                        };

                        art: partition@50000 {
                                label = "art";
                                reg = <0x050000 0x010000>;
                        };

                        partition@60000 {
                                compatible = "denx,uimage";
                                label = "firmware";
                                reg = <0x060000 0xfa0000>;
                        };
                };
        };
};

&eth0 {
        status = "okay";
        phy-handle = <&swphy4>;
};

&eth1 {
        status = "okay";
};

&wmac {
        status = "okay";
        mtd-cal-data = <&art 0x1000>;
};