OpenWrt – Rev 1

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "ar9331.dtsi"

/ {
        aliases {
                serial0 = &uart;
                led-boot = &system;
                led-failsafe = &system;
                led-running = &system;
                led-upgrade = &system;
        };

        keys {
                compatible = "gpio-keys-polled";
                poll-interval = <20>;

                reset {
                        label = "reset";
                        linux,code = <KEY_RESTART>;
                        gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
                        debounce-interval = <60>;
                };
        };

        leds {
                compatible = "gpio-leds";

                system: system {
                        label = "tl-wr703n:blue:system";
                        gpios = <&gpio 27 GPIO_ACTIVE_LOW>;
                };
        };

        reg_usb_vbus: reg_usb_vbus {
                compatible = "regulator-fixed";
                regulator-name = "usb_vbus";
                regulator-min-microvolt = <5000000>;
                regulator-max-microvolt = <5000000>;
                enable-active-high;
        };

};

&spi {
        status = "okay";
        num-cs = <1>;

        flash@0 {
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <25000000>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        uboot: partition@0 {
                                reg = <0x0 0x20000>;
                                label = "u-boot";
                                read-only;
                        };

                        firmware: partition@20000 {
                                compatible = "tplink,firmware";
                                reg = <0x20000 0x3d0000>;
                                label = "firmware";
                        };

                        art: partition@3f0000 {
                                reg = <0x3f0000 0x10000>;
                                label = "art";
                                read-only;
                        };
                };
        };
};

&eth0 {
        status = "okay";

        mtd-mac-address = <&uboot 0x1fc00>;

        gmac-config {
                device = <&gmac>;

                switch-phy-addr-swap = <0>;
                switch-phy-swap = <0>;
        };
};

&eth1 {
        status = "okay";
        compatible = "syscon", "simple-mfd";
};

&gpio {
        status = "okay";
};

&uart {
        status = "okay";
};

&usb {
        dr_mode = "host";
        vbus-supply = <&reg_usb_vbus>;
        status = "okay";
};

&usb_phy {
        status = "okay";
};

&wmac {
        status = "okay";
        mtd-cal-data = <&art 0x1000>;
        mtd-mac-address = <&uboot 0x1fc00>;
};