OpenWrt – Rev 4
?pathlinks?
#include "vr9.dtsi"
#include <dt-bindings/input/input.h>
/ {
compatible = "arcadyan,vgv7519", "lantiq,xway", "lantiq,vr9";
chosen {
bootargs = "console=ttyLTQ0,115200 mem=62M vpe1_load_addr=0x83e00000 vpe1_mem=2M maxvpes=1 maxtcs=1 nosmp";
};
aliases {
led-boot = &power_green;
led-failsafe = &power_red;
led-running = &power_green;
led-dsl = &broadband_green;
led-internet = &internet_green;
led-wifi = &wireless_green;
};
sram@1F000000 {
vmmc@107000 {
status = "okay";
gpios = <&gpio 30 GPIO_ACTIVE_HIGH //fxs relay
&gpio 31 GPIO_ACTIVE_HIGH //still unknown
&gpio 3 GPIO_ACTIVE_HIGH>; //reset_slic?
};
};
memory@0 {
reg = <0x0 0x4000000>;
};
fpi@10000000 {
localbus@0 {
nor-boot@0 {
compatible = "lantiq,nor";
bank-width = <2>;
reg = <0 0x0 0x800000>, <1 0x800000 0x800000>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
boardconfig: partition@40000 {
label = "board_config";
reg = <0x40000 0x10000>;
read-only;
};
};
};
};
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
stp {
lantiq,groups = "stp";
lantiq,function = "stp";
lantiq,open-drain = <0>;
lantiq,output = <1>;
lantiq,pull = <0>;
};
mdio {
lantiq,groups = "mdio";
lantiq,function = "mdio";
};
pci-rst {
lantiq,pins = "io21";
lantiq,open-drain = <0>;
lantiq,pull = <0>;
lantiq,output = <1>;
};
gphy-leds {
lantiq,groups = "gphy0 led1", "gphy1 led0";
lantiq,function = "gphy";
lantiq,open-drain = <0>;
lantiq,pull = <0>;
lantiq,output = <1>;
};
};
};
stp: stp@E100BB0 {
compatible = "lantiq,gpio-stp-xway";
reg = <0xE100BB0 0x40>;
#gpio-cells = <2>;
gpio-controller;
lantiq,shadow = <0xffff>;
lantiq,groups = <0x3>;
lantiq,dsl = <0x0>;
lantiq,phy1 = <0x0>;
lantiq,phy2 = <0x0>;
/* lantiq,rising; */
};
ifxhcd@E101000 {
status = "okay";
gpios = <&gpio 32 GPIO_ACTIVE_HIGH>;
lantiq,portmask = <0x3>;
};
ifxhcd@E106000 {
status = "okay";
gpios = <&gpio 32 GPIO_ACTIVE_HIGH>;
};
pcie@d900000 {
status = "disabled";
};
};
gphy-xrx200 {
compatible = "lantiq,phy-xrx200";
firmware1 = "lantiq/xrx200_phy11g_a14.bin"; /*VR9 1.1*/
firmware2 = "lantiq/xrx200_phy11g_a22.bin"; /*VR9 1.2*/
phys = [ 00 01 ];
};
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <100>;
reset {
label = "reset";
gpios = <&gpio 9 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RESTART>;
};
eco {
label = "eco";
gpios = <&gpio 41 GPIO_ACTIVE_LOW>;
linux,code = <BTN_0>;
};
rfkill {
label = "rfkill";
gpios = <&gpio 45 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RFKILL>;
};
wps {
label = "wps";
gpios = <&gpio 10 GPIO_ACTIVE_LOW>;
linux,code = <KEY_WPS_BUTTON>;
};
};
gpio-leds {
compatible = "gpio-leds";
eco {
label = "vgv7519:blue:eco";
gpios = <&stp 2 GPIO_ACTIVE_LOW>;
};
wps_red {
label = "vgv7519:red:wps";
gpios = <&stp 3 GPIO_ACTIVE_LOW>;
};
wps_green {
label = "vgv7519:green:wps";
gpios = <&stp 4 GPIO_ACTIVE_LOW>;
};
upgrade {
label = "vgv7519:blue:upgrade";
gpios = <&stp 5 GPIO_ACTIVE_LOW>;
};
tv {
label = "vgv7519:green:tv";
gpios = <&stp 6 GPIO_ACTIVE_LOW>;
};
internet_green: internet_green {
label = "vgv7519:green:internet";
gpios = <&stp 7 GPIO_ACTIVE_LOW>;
};
internet_red {
label = "vgv7519:red:internet";
gpios = <&stp 8 GPIO_ACTIVE_LOW>;
};
broadband_red {
label = "vgv7519:red:broadband";
gpios = <&stp 9 GPIO_ACTIVE_LOW>;
};
broadband_green: broadband_green {
label = "vgv7519:green:broadband";
gpios = <&stp 10 GPIO_ACTIVE_LOW>;
};
voice {
label = "vgv7519:green:voice";
gpios = <&stp 11 GPIO_ACTIVE_LOW>;
};
wireless_red {
label = "vgv7519:red:wireless";
gpios = <&stp 12 GPIO_ACTIVE_LOW>;
};
wireless_green: wireless_green {
label = "vgv7519:green:wireless";
gpios = <&stp 13 GPIO_ACTIVE_LOW>;
};
power_green: power2 {
label = "vgv7519:green:power";
gpios = <&stp 14 GPIO_ACTIVE_LOW>;
default-state = "keep";
};
power_red: power {
label = "vgv7519:red:power";
gpios = <&stp 15 GPIO_ACTIVE_LOW>;
};
};
};
&pci0 {
status = "okay";
gpio-reset = <&gpio 21 GPIO_ACTIVE_HIGH>;
wifi@1814,3091 {
compatible = "pci1814,3091";
reg = <0x7000 0 0 0 0>;
ralink,mtd-eeprom = <&boardconfig 0x410>;
ralink,mtd-eeprom-swap;
mtd-mac-address = <&boardconfig 0x16>;
mtd-mac-address-increment = <1>;
};
};
ð0 {
lan: interface@0 {
compatible = "lantiq,xrx200-pdi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0>;
mtd-mac-address = <&boardconfig 0x16>;
mtd-mac-address-increment = <1>;
lantiq,switch;
ethernet@0 {
compatible = "lantiq,xrx200-pdi-port";
reg = <0>;
phy-mode = "rgmii";
phy-handle = <&phy0>;
};
ethernet@1 {
compatible = "lantiq,xrx200-pdi-port";
reg = <1>;
phy-mode = "rgmii";
phy-handle = <&phy1>;
};
ethernet@2 {
compatible = "lantiq,xrx200-pdi-port";
reg = <2>;
phy-mode = "gmii";
phy-handle = <&phy11>;
};
ethernet@4 {
compatible = "lantiq,xrx200-pdi-port";
reg = <4>;
phy-mode = "gmii";
phy-handle = <&phy13>;
};
ethernet@5 {
compatible = "lantiq,xrx200-pdi-port";
reg = <5>;
phy-mode = "rgmii";
phy-handle = <&phy5>;
};
};
mdio@0 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "lantiq,xrx200-mdio";
phy0: ethernet-phy@0 {
reg = <0x0>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy1: ethernet-phy@1 {
reg = <0x1>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy5: ethernet-phy@5 {
reg = <0x5>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy11: ethernet-phy@11 {
reg = <0x11>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
phy13: ethernet-phy@13 {
reg = <0x13>;
compatible = "lantiq,phy11g", "ethernet-phy-ieee802.3-c22";
};
};
};