OpenWrt – Rev 4
?pathlinks?
#include "vr9.dtsi"
#include <dt-bindings/input/input.h>
/ {
compatible = "arcadyan,vgv7510kw22", "lantiq,xway", "lantiq,vr9";
chosen {
bootargs = "console=ttyLTQ0,115200 mem=62M vpe1_load_addr=0x83e00000 vpe1_mem=2M maxvpes=1 maxtcs=1 nosmp";
};
aliases {
led-boot = &power_green;
led-failsafe = &power_red;
led-running = &power_green;
led-dsl = &dsl;
led-internet = &internet_green;
led-wifi = &wifi;
};
sram@1F000000 {
vmmc@107000 {
status = "okay";
gpios = <&gpio 30 GPIO_ACTIVE_HIGH //fxs relay
&gpio 31 GPIO_ACTIVE_HIGH //still unknown
&gpio 3 GPIO_ACTIVE_HIGH>; //reset_slic?
};
};
memory@0 {
reg = <0x0 0x4000000>;
};
fpi@10000000 {
localbus@0 {
nor-boot@0 {
compatible = "lantiq,nor";
bank-width = <2>;
reg = <0 0x0 0x1000000>;
#address-cells = <1>;
#size-cells = <1>;
partitions {
compatible = "fixed-partitions";
#address-cells = <1>;
#size-cells = <1>;
boardconfig: partition@fe0000 {
label = "board_config";
reg = <0xfe0000 0x20000>;
read-only;
};
};
};
};
gpio: pinmux@E100B10 {
pinctrl-names = "default";
pinctrl-0 = <&state_default>;
state_default: pinmux {
gphy-leds {
lantiq,groups = "gphy0 led0", "gphy0 led1",
"gphy1 led0", "gphy1 led1";
lantiq,function = "gphy";
lantiq,open-drain = <0>;
lantiq,pull = <2>;
lantiq,output = <1>;
};
mdio {
lantiq,groups = "mdio";
lantiq,function = "mdio";
};
pci-rst {
lantiq,pins = "io21";
lantiq,open-drain = <0>;
lantiq,pull = <0>;
lantiq,output = <1>;
};
};
};
ifxhcd@E101000 {
status = "okay";
gpios = <&gpio 47 GPIO_ACTIVE_HIGH>;
};
pcie@d900000 {
status = "disabled";
};
};
gphy-xrx200 {
compatible = "lantiq,phy-xrx200";
firmware1 = "lantiq/xrx200_phy22f_a14.bin"; /*VR9 1.1*/
firmware2 = "lantiq/xrx200_phy22f_a22.bin"; /*VR9 1.2*/
phys = [ 00 01 ];
};
gpio-keys-polled {
compatible = "gpio-keys-polled";
#address-cells = <1>;
#size-cells = <0>;
poll-interval = <100>;
reset {
label = "reset";
gpios = <&gpio 6 GPIO_ACTIVE_LOW>;
linux,code = <KEY_RESTART>;
};
wps {
label = "wps";
gpios = <&gpio 9 GPIO_ACTIVE_LOW>;
linux,code = <KEY_WPS_BUTTON>;
};
};
gpio-leds {
compatible = "gpio-leds";
dsl: dsl {
label = "vgv7510kw22:green:dsl";
gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
};
internet_red {
label = "vgv7510kw22:red:internet";
gpios = <&gpio 10 GPIO_ACTIVE_LOW>;
};
info_red {
label = "vgv7510kw22:red:info";
gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
};
power_green: power {
label = "vgv7510kw22:green:power";
gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
default-state = "keep";
};
info_green {
label = "vgv7510kw22:green:info";
gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
};
internet_green: internet_green {
label = "vgv7510kw22:green:internet";
gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
};
wifi: wifi {
label = "vgv7510kw22:green:wlan";
gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
};
power_red: power2 {
label = "vgv7510kw22:red:power";
gpios = <&gpio 28 GPIO_ACTIVE_LOW>;
};
phone {
label = "vgv7510kw22:green:telefon";
gpios = <&gpio 29 GPIO_ACTIVE_LOW>;
};
};
};
&pci0 {
status = "okay";
gpio-reset = <&gpio 21 GPIO_ACTIVE_HIGH>;
wifi@1814,3592 {
compatible = "pci1814,3592";
reg = <0x7000 0 0 0 0>;
ralink,mtd-eeprom = <&boardconfig 0x410>;
ralink,mtd-eeprom-swap;
mtd-mac-address = <&boardconfig 0x16>;
mtd-mac-address-increment = <1>;
};
};
ð0 {
lan: interface@0 {
compatible = "lantiq,xrx200-pdi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0>;
mtd-mac-address = <&boardconfig 0x16>;
lantiq,switch;
ethernet@0 {
compatible = "lantiq,xrx200-pdi-port";
reg = <0>;
phy-mode = "mii";
phy-handle = <&phy1>;
};
ethernet@2 {
compatible = "lantiq,xrx200-pdi-port";
reg = <2>;
phy-mode = "mii";
phy-handle = <&phy11>;
};
ethernet@3 {
compatible = "lantiq,xrx200-pdi-port";
reg = <3>;
phy-mode = "mii";
phy-handle = <&phy12>;
};
ethernet@4 {
compatible = "lantiq,xrx200-pdi-port";
reg = <4>;
phy-mode = "mii";
phy-handle = <&phy13>;
};
ethernet@5 {
compatible = "lantiq,xrx200-pdi-port";
reg = <5>;
phy-mode = "mii";
phy-handle = <&phy14>;
};
};
mdio@0 {
#address-cells = <1>;
#size-cells = <0>;
compatible = "lantiq,xrx200-mdio";
phy1: ethernet-phy@1 {
reg = <0x1>;
compatible = "ethernet-phy-ieee802.3-c22";
};
phy11: ethernet-phy@11 {
reg = <0x11>;
compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
};
phy12: ethernet-phy@12 {
reg = <0x12>;
compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
};
phy13: ethernet-phy@13 {
reg = <0x13>;
compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
};
phy14: ethernet-phy@14 {
reg = <0x14>;
compatible = "lantiq,phy22f", "ethernet-phy-ieee802.3-c22";
};
};
};