OpenWrt – Rev 4

Subversion Repositories:
Rev:

#include <dt-bindings/interrupt-controller/irq.h>
#include <dt-bindings/gpio/gpio.h>

/ {
        compatible = "lantiq,easy98000", "lantiq,falcon";

        memory@0 {
                device_type = "memory";
                reg = <0x0 0x4000000>;
        };

        easy98000-leds {
                compatible = "gpio-leds";
                pinctrl-names = "default";
                pinctrl-0 = <&bootled_pins>;

                LED_0 {
                        label = "easy98000:green:gpon";
                        gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
                LED_1 {
                        label = "easy98000:red:gpon";
                        gpios = <&gpio0 10 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
                LED_2 {
                        label = "easy98000:green:gpon_tx";
                        gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
                LED_3 {
                        label = "easy98000:green:gpon_rx";
                        gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
                LED_4 {
                        label = "easy98000:green:voice";
                        gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
                LED_5 {
                        label = "easy98000:green:status";
                        gpios = <&gpio0 14 GPIO_ACTIVE_HIGH>;
                        default-state = "keep";
                };
        };
};

&ebu_cs1 {
        eth0: ethernet@0000000 {
                compatible = "davicom,dm9000";
                device_type = "network";
                reg = <0x0000003 0x1>, <0x0000001 0x1>;
                reg-names = "addr", "data";
                interrupt-parent = <&gpio1>;
                #interrupt-cells = <2>;
                interrupts = <10 IRQ_TYPE_LEVEL_LOW>;
                local-mac-address = [ 00 00 00 00 00 00 ];
        };

        cpld@3c00000 {
                compatible = "lantiq,easy98000_addon";
                reg = <0x3c00000 0x2>;
        };

        cpld@3c0000c {
                compatible = "lantiq,easy98000_cpld_led";
                reg = <0x3c0000c 0x2>,  <0x3c00012 0x2>;
        };
};

/* // enable this for second uart:
&serial1 {
        status = "okay";
};*/

&spi {
        status = "okay";

        eeprom@1 {
                compatible = "atmel,at25", "atmel,at25160n";
                reg = <2>;
                spi-max-frequency = <1000000>;
                spi-cpha;
                spi-cpol;

                pagesize = <32>;
                size = <2048>;
                address-width = <16>;
        };
};

&i2c {
        status = "okay";

        clock-frequency = <100000>;

        /* eeprom-emulation by OMU */
        eeprom@50 {
                compatible = "at,24c02";
                reg = <0x50>;
        };
        eeprom@51 {
                compatible = "at,24c02";
                reg = <0x51>;
        };
};