OpenWrt – Rev 4
?pathlinks?
From da472385a29f1fddcac7cfa0499482704310bd16 Mon Sep 17 00:00:00 2001
From: Arend Van Spriel <arend.vanspriel@broadcom.com>
Date: Tue, 20 Feb 2018 00:14:18 +0100
Subject: [PATCH] brcmfmac: move brcmf_bus_preinit() call just after changing
bus state
Moving the brcmf_bus_preinit() call allows the bus code to do some
required initialization before handling firmware control messages.
Reviewed-by: Hante Meuleman <hante.meuleman@broadcom.com>
Reviewed-by: Pieter-Paul Giesberts <pieter-paul.giesberts@broadcom.com>
Reviewed-by: Franky Lin <franky.lin@broadcom.com>
Signed-off-by: Arend van Spriel <arend.vanspriel@broadcom.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/common.c | 3 ---
drivers/net/wireless/broadcom/brcm80211/brcmfmac/core.c | 5 +++++
2 files changed, 5 insertions(+), 3 deletions(-)
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/common.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/common.c
@@ -369,9 +369,6 @@ int brcmf_c_preinit_dcmds(struct brcmf_i
/* Enable tx beamforming, errors can be ignored (not supported) */
(void)brcmf_fil_iovar_int_set(ifp, "txbf", 1);
-
- /* do bus specific preinit here */
- err = brcmf_bus_preinit(ifp->drvr->bus_if);
done:
return err;
}
--- a/drivers/net/wireless/broadcom/brcm80211/brcmfmac/core.c
+++ b/drivers/net/wireless/broadcom/brcm80211/brcmfmac/core.c
@@ -1091,6 +1091,11 @@ int brcmf_bus_started(struct device *dev
/* signal bus ready */
brcmf_bus_change_state(bus_if, BRCMF_BUS_UP);
+ /* do bus specific preinit here */
+ ret = brcmf_bus_preinit(ifp->drvr->bus_if);
+ if (ret < 0)
+ goto fail;
+
/* Bus is ready, do any initialization */
ret = brcmf_c_preinit_dcmds(ifp);
if (ret < 0)