OpenWrt – Rev 3

Subversion Repositories:
Rev:
/dts-v1/;

#include "rt3050.dtsi"

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

/ {
        compatible = "sitecom,wl-351", "ralink,rt3052-soc";
        model = "Sitecom WL-351 v1 002";

        cfi@1f000000 {
                compatible = "cfi-flash";
                reg = <0x1f000000 0x800000>;
                bank-width = <2>;
                device-width = <2>;
                #address-cells = <1>;
                #size-cells = <1>;

                partition@0 {
                        label = "u-boot";
                        reg = <0x0 0x30000>;
                        read-only;
                };

                partition@30000 {
                        label = "u-boot-env";
                        reg = <0x30000 0x10000>;
                        read-only;
                };

                factory: partition@40000 {
                        label = "factory";
                        reg = <0x40000 0x10000>;
                        read-only;
                };

                partition@50000 {
                        label = "firmware";
                        reg = <0x50000 0x3b0000>;
                };
        };

        gpio-leds {
                compatible = "gpio-leds";

                power {
                        label = "wl-351:amber:power";
                        gpios = <&gpio0 8 GPIO_ACTIVE_LOW>;
                };

                unpopulated {
                        label = "wl-351:amber:unpopulated";
                        gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
                };

                unpopulated2 {
                        label = "wl-351:blue:unpopulated";
                        gpios = <&gpio0 13 GPIO_ACTIVE_LOW>;
                };
        };

        gpio-keys-polled {
                compatible = "gpio-keys-polled";
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <20>;

                reset {
                        label = "reset";
                        gpios = <&gpio0 10 GPIO_ACTIVE_LOW>;
                        linux,code = <KEY_RESTART>;
                };

                wps {
                        label = "wps";
                        gpios = <&gpio0 0 GPIO_ACTIVE_LOW>;
                        linux,code = <KEY_WPS_BUTTON>;
                };
        };

        rtl8366rb {
                compatible = "realtek,rtl8366rb";
                gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>;
                gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>;
        };
};

&pinctrl {
        state_default: pinctrl0 {
                gpio {
                        ralink,group = "spi", "i2c", "jtag", "mdio", "uartf";
                        ralink,function = "gpio";
                };
        };
};

&ethernet {
        mtd-mac-address = <&factory 0x4>;
        pinctrl-names = "default";
        pinctrl-0 = <&rgmii_pins>;
};

&esw {
        ralink,rgmii = <1>;
        mediatek,portmap = <0x3f>;
        ralink,fct2 = <0x0002500c>;
        /*
         * ext phy base addr 31, rx/tx clock skew 0,
         * turbo mii off, rgmi 3.3v off, port 5 polling off
         * port5: enabled, gige, full-duplex, rx/tx-flow-control
         * port6: enabled, gige, full-duplex, rx/tx-flow-control
        */
        ralink,fpa2 = <0x1f003fff>;
};

&wmac {
        ralink,mtd-eeprom = <&factory 0>;
};

&otg {
        status = "okay";
};