OpenWrt – Rev 3

Subversion Repositories:
Rev:
/dts-v1/;

#include "rt2880.dtsi"

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

/ {
        compatible = "ralink,v11st-fe", "ralink,rt2880-soc";
        model = "Ralink V11ST-FE";

        pci@440000 {
                status = "okay";

                host-bridge {
                        pci-bridge@1 {
                                status = "okay";
                        };
                };
        };

        nor-flash@1c000000 {
                compatible = "cfi-flash";
                reg = <0x1c000000 0x800000>;
                bank-width = <2>;
                #address-cells = <1>;
                #size-cells = <1>;

                partition@0 {
                        reg = <0x0 0x0030000>;
                        label = "u-boot";
                        read-only;
                };

                partition@30000 {
                        reg = <0x00030000 0x00010000>;
                        label = "u-boot-env";
                        read-only;
                };

                factory: partition@40000 {
                        reg = <0x00040000 0x00010000>;
                        label = "factory";
                        read-only;
                };

                partition@50000 {
                        reg = <0x00050000 0x003b0000>;
                        label = "firmware";
                };
        };

        gpio-keys-polled {
                compatible = "gpio-keys-polled";
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <100>;

                wps {
                        label = "wps";
                        gpios = <&gpio0 0 GPIO_ACTIVE_HIGH>;
                        linux,code = <KEY_WPS_BUTTON>;
                };
        };

        gpio-leds {
                compatible = "gpio-leds";

                status {
                        label = "v11st-fe:green:status";
                        gpios = <&gpio0 12 GPIO_ACTIVE_LOW>;
                };
        };
};

&gpio0 {
        status = "okay";
};

&ethernet {
        status = "okay";
};

&wmac {
        ralink,mtd-eeprom = <&factory 0>;
};