OpenWrt – Rev 3

?pathlinks?

Rev 2 – Blame – Compare with Previous – Last modification – View Log – Download

/dts-v1/;

#include "bcm6328.dtsi"

#include <dt-bindings/input/input.h>

/ {
        model = "Broadcom BCM96328avng reference board";
        compatible = "brcm,bcm96328avng", "brcm,bcm6328";

        chosen {
                bootargs = "rootfstype=squashfs,jffs2 noinitrd console=ttyS0,115200";
                stdout-path = "serial0:115200n8";
        };

        gpio-leds {
                compatible = "gpio-leds";

                inet_fail {
                        label = "96328avng::internet-fail";
                        gpios = <&pinctrl 2 1>;
                };
                dsl {
                        label = "96328avng::dsl";
                        gpios = <&pinctrl 3 1>;
                };
                power {
                        label = "96328avng::power";
                        gpios = <&pinctrl 4 1>;
                        default-state = "on";
                };
                power_fail {
                        label = "96328avng::power-fail";
                        gpios = <&pinctrl 8 1>;
                };
                wps {
                        label = "96328avng::wps";
                        gpios = <&pinctrl 9 1>;
                };
                inet {
                        label = "96328avng::internet";
                        gpios = <&pinctrl 11 1>;
                };
        };
};

&hsspi {
        status = "ok";

        flash@0 {
                compatible = "jedec,spi-nor";
                spi-max-frequency = <16666667>;
                spi-tx-bus-width = <2>;
                spi-rx-bus-width = <2>;
                reg = <0>;

                #address-cells = <1>;
                #size-cells = <1>;

                linux,part-probe = "bcm63xxpart";

                partitions {
                        compatible = "brcm,bcm963xx-cfe-nor-partitions";
                };
        };
};

&pinctrl {
        pinctrl-names = "default";
        pinctrl-0 = <&pinctrl_usb_port1_device>;
};

&uart0 {
        status = "ok";
};