OpenWrt – Rev 4
?pathlinks?
--- a/drivers/ssb/pcihost_wrapper.c
+++ b/drivers/ssb/pcihost_wrapper.c
@@ -11,15 +11,17 @@
* Licensed under the GNU/GPL. See COPYING for details.
*/
+#include <linux/pm.h>
#include <linux/pci.h>
#include <linux/export.h>
#include <linux/slab.h>
#include <linux/ssb/ssb.h>
-#ifdef CONFIG_PM
-static int ssb_pcihost_suspend(struct pci_dev *dev, pm_message_t state)
+#ifdef CONFIG_PM_SLEEP
+static int ssb_pcihost_suspend(struct device *d)
{
+ struct pci_dev *dev = to_pci_dev(d);
struct ssb_bus *ssb = pci_get_drvdata(dev);
int err;
@@ -28,17 +30,23 @@ static int ssb_pcihost_suspend(struct pc
return err;
pci_save_state(dev);
pci_disable_device(dev);
- pci_set_power_state(dev, pci_choose_state(dev, state));
+
+ /* if there is a wakeup enabled child device on ssb bus,
+ enable pci wakeup posibility. */
+ device_set_wakeup_enable(d, d->power.wakeup_path);
+
+ pci_prepare_to_sleep(dev);
return 0;
}
-static int ssb_pcihost_resume(struct pci_dev *dev)
+static int ssb_pcihost_resume(struct device *d)
{
+ struct pci_dev *dev = to_pci_dev(d);
struct ssb_bus *ssb = pci_get_drvdata(dev);
int err;
- pci_set_power_state(dev, PCI_D0);
+ pci_back_from_sleep(dev);
err = pci_enable_device(dev);
if (err)
return err;
@@ -49,10 +57,12 @@ static int ssb_pcihost_resume(struct pci
return 0;
}
-#else /* CONFIG_PM */
-# define ssb_pcihost_suspend NULL
-# define ssb_pcihost_resume NULL
-#endif /* CONFIG_PM */
+
+static const struct dev_pm_ops ssb_pcihost_pm_ops = {
+ SET_SYSTEM_SLEEP_PM_OPS(ssb_pcihost_suspend, ssb_pcihost_resume)
+};
+
+#endif /* CONFIG_PM_SLEEP */
static int ssb_pcihost_probe(struct pci_dev *dev,
const struct pci_device_id *id)
@@ -115,8 +125,9 @@ int ssb_pcihost_register(struct pci_driv
{
driver->probe = ssb_pcihost_probe;
driver->remove = ssb_pcihost_remove;
- driver->suspend = ssb_pcihost_suspend;
- driver->resume = ssb_pcihost_resume;
+#ifdef CONFIG_PM_SLEEP
+ driver->driver.pm = &ssb_pcihost_pm_ops;
+#endif
return pci_register_driver(driver);
}
--- a/drivers/ssb/driver_pcicore.c
+++ b/drivers/ssb/driver_pcicore.c
@@ -357,6 +357,16 @@ static void ssb_pcicore_init_hostmode(st
pcicore_write32(pc, SSB_PCICORE_SBTOPCI2,
SSB_PCICORE_SBTOPCI_MEM | SSB_PCI_DMA);
+ /*
+ * Accessing PCI config without a proper delay after devices reset (not
+ * GPIO reset) was causing reboots on WRT300N v1.0 (BCM4704).
+ * Tested delay 850 us lowered reboot chance to 50-80%, 1000 us fixed it
+ * completely. Flushing all writes was also tested but with no luck.
+ * The same problem was reported for WRT350N v1 (BCM4705), so we just
+ * sleep here unconditionally.
+ */
+ usleep_range(1000, 2000);
+
/* Enable PCI bridge BAR0 prefetch and burst */
val = PCI_COMMAND_MASTER | PCI_COMMAND_MEMORY;
ssb_extpci_write_config(pc, 0, 0, 0, PCI_COMMAND, &val, 2);
--- a/drivers/ssb/main.c
+++ b/drivers/ssb/main.c
@@ -90,25 +90,6 @@ found:
}
#endif /* CONFIG_SSB_PCMCIAHOST */
-#ifdef CONFIG_SSB_SDIOHOST
-struct ssb_bus *ssb_sdio_func_to_bus(struct sdio_func *func)
-{
- struct ssb_bus *bus;
-
- ssb_buses_lock();
- list_for_each_entry(bus, &buses, list) {
- if (bus->bustype == SSB_BUSTYPE_SDIO &&
- bus->host_sdio == func)
- goto found;
- }
- bus = NULL;
-found:
- ssb_buses_unlock();
-
- return bus;
-}
-#endif /* CONFIG_SSB_SDIOHOST */
-
int ssb_for_each_bus_call(unsigned long data,
int (*func)(struct ssb_bus *bus, unsigned long data))
{
@@ -1154,6 +1135,8 @@ static u32 ssb_tmslow_reject_bitmask(str
case SSB_IDLOW_SSBREV_25: /* TODO - find the proper REJECT bit */
case SSB_IDLOW_SSBREV_27: /* same here */
return SSB_TMSLOW_REJECT; /* this is a guess */
+ case SSB_IDLOW_SSBREV:
+ break;
default:
WARN(1, KERN_INFO "ssb: Backplane Revision 0x%.8X\n", rev);
}