OpenWrt – Rev 1
?pathlinks?
/*
* Marvell 88E6060 switch driver
* Copyright (c) 2008 Felix Fietkau <nbd@nbd.name>
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of the GNU General Public License v2 as published by the
* Free Software Foundation
*/
#ifndef __MVSWITCH_H
#define __MVSWITCH_H
#define MV_HEADER_SIZE 2
#define MV_HEADER_PORTS_M 0x001f
#define MV_HEADER_PORTS_S 0
#define MV_HEADER_VLAN_M 0xf000
#define MV_HEADER_VLAN_S 12
#define MV_TRAILER_SIZE 4
#define MV_TRAILER_PORTS_M 0x1f
#define MV_TRAILER_PORTS_S 16
#define MV_TRAILER_FLAGS_S 24
#define MV_TRAILER_OVERRIDE 0x80
#define MV_PORTS 5
#define MV_WANPORT 4
#define MV_CPUPORT 5
#define MV_BASE 0x10
#define MV_PHYPORT_BASE (MV_BASE + 0x0)
#define MV_PHYPORT(_n) (MV_PHYPORT_BASE + (_n))
#define MV_SWITCHPORT_BASE (MV_BASE + 0x8)
#define MV_SWITCHPORT(_n) (MV_SWITCHPORT_BASE + (_n))
#define MV_SWITCHREGS (MV_BASE + 0xf)
enum {
MV_PHY_CONTROL = 0x00,
MV_PHY_STATUS = 0x01,
MV_PHY_IDENT0 = 0x02,
MV_PHY_IDENT1 = 0x03,
MV_PHY_ANEG = 0x04,
MV_PHY_LINK_ABILITY = 0x05,
MV_PHY_ANEG_EXPAND = 0x06,
MV_PHY_XMIT_NEXTP = 0x07,
MV_PHY_LINK_NEXTP = 0x08,
MV_PHY_CONTROL1 = 0x10,
MV_PHY_STATUS1 = 0x11,
MV_PHY_INTR_EN = 0x12,
MV_PHY_INTR_STATUS = 0x13,
MV_PHY_INTR_PORT = 0x14,
MV_PHY_RECV_COUNTER = 0x16,
MV_PHY_LED_PARALLEL = 0x16,
MV_PHY_LED_STREAM = 0x17,
MV_PHY_LED_CTRL = 0x18,
MV_PHY_LED_OVERRIDE = 0x19,
MV_PHY_VCT_CTRL = 0x1a,
MV_PHY_VCT_STATUS = 0x1b,
MV_PHY_CONTROL2 = 0x1e
};
#define MV_PHYREG(_type, _port) MV_PHYPORT(_port), MV_PHY_##_type
enum {
MV_PORT_STATUS = 0x00,
MV_PORT_IDENT = 0x03,
MV_PORT_CONTROL = 0x04,
MV_PORT_VLANMAP = 0x06,
MV_PORT_ASSOC = 0x0b,
MV_PORT_RXCOUNT = 0x10,
MV_PORT_TXCOUNT = 0x11,
};
#define MV_PORTREG(_type, _port) MV_SWITCHPORT(_port), MV_PORT_##_type
enum {
MV_PORTCTRL_BLOCK = (1 << 0),
MV_PORTCTRL_LEARN = (2 << 0),
MV_PORTCTRL_ENABLED = (3 << 0),
MV_PORTCTRL_VLANTUN = (1 << 7), /* Enforce VLANs on packets */
MV_PORTCTRL_RXTR = (1 << 8), /* Enable Marvell packet trailer for ingress */
MV_PORTCTRL_HEADER = (1 << 11), /* Enable Marvell packet header mode for port */
MV_PORTCTRL_TXTR = (1 << 14), /* Enable Marvell packet trailer for egress */
MV_PORTCTRL_FORCEFL = (1 << 15), /* force flow control */
};
#define MV_PORTVLAN_ID(_n) (((_n) & 0xf) << 12)
#define MV_PORTVLAN_PORTS(_n) ((_n) & 0x3f)
#define MV_PORTASSOC_PORTS(_n) ((_n) & 0x1f)
#define MV_PORTASSOC_MONITOR (1 << 15)
enum {
MV_SWITCH_MAC0 = 0x01,
MV_SWITCH_MAC1 = 0x02,
MV_SWITCH_MAC2 = 0x03,
MV_SWITCH_CTRL = 0x04,
MV_SWITCH_ATU_CTRL = 0x0a,
MV_SWITCH_ATU_OP = 0x0b,
MV_SWITCH_ATU_DATA = 0x0c,
MV_SWITCH_ATU_MAC0 = 0x0d,
MV_SWITCH_ATU_MAC1 = 0x0e,
MV_SWITCH_ATU_MAC2 = 0x0f,
};
#define MV_SWITCHREG(_type) MV_SWITCHREGS, MV_SWITCH_##_type
enum {
MV_SWITCHCTL_EEIE = (1 << 0), /* EEPROM interrupt enable */
MV_SWITCHCTL_PHYIE = (1 << 1), /* PHY interrupt enable */
MV_SWITCHCTL_ATUDONE= (1 << 2), /* ATU done interrupt enable */
MV_SWITCHCTL_ATUIE = (1 << 3), /* ATU interrupt enable */
MV_SWITCHCTL_CTRMODE= (1 << 8), /* statistics for rx and tx errors */
MV_SWITCHCTL_RELOAD = (1 << 9), /* reload registers from eeprom */
MV_SWITCHCTL_MSIZE = (1 << 10), /* increase maximum frame size */
MV_SWITCHCTL_DROP = (1 << 13), /* discard frames with excessive collisions */
};
enum {
#define MV_ATUCTL_AGETIME_MIN 16
#define MV_ATUCTL_AGETIME_MAX 4080
#define MV_ATUCTL_AGETIME(_n) ((((_n) / 16) & 0xff) << 4)
MV_ATUCTL_ATU_256 = (0 << 12),
MV_ATUCTL_ATU_512 = (1 << 12),
MV_ATUCTL_ATU_1K = (2 << 12),
MV_ATUCTL_ATUMASK = (3 << 12),
MV_ATUCTL_NO_LEARN = (1 << 14),
MV_ATUCTL_RESET = (1 << 15),
};
enum {
#define MV_ATUOP_DBNUM(_n) ((_n) & 0x0f)
MV_ATUOP_NOOP = (0 << 12),
MV_ATUOP_FLUSH_ALL = (1 << 12),
MV_ATUOP_FLUSH_U = (2 << 12),
MV_ATUOP_LOAD_DB = (3 << 12),
MV_ATUOP_GET_NEXT = (4 << 12),
MV_ATUOP_FLUSH_DB = (5 << 12),
MV_ATUOP_FLUSH_DB_UU= (6 << 12),
MV_ATUOP_INPROGRESS = (1 << 15),
};
#define MV_IDENT_MASK 0xfff0
#define MV_IDENT_VALUE 0x0600
#endif