OpenWrt – Rev 4

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "ar9342_ubnt_wa.dtsi"

/ {
        compatible = "ubnt,nanostation-ac","ubnt,wa", "qca,ar9342";
        model = "Ubiquiti Nanostation AC (WA)";

        leds {
                compatible = "gpio-leds";

                rssi0 {
                        label = "ubnt:blue:rssi0";
                        gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
                };

                rssi1 {
                        label = "ubnt:blue:rssi1";
                        gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
                };

                rssi2 {
                        label = "ubnt:blue:rssi2";
                        gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
                };

                rssi3 {
                        label = "ubnt:blue:rssi3";
                        gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
                };
        };
};

&mdio0 {
        status = "okay";

        phy-mask = <4>;
        phy0: ethernet-phy@0 {
                phy-mode = "rgmii";
                reg = <0>;

                qca,ar8327-initvals = <
                        0x04 0x07600000 /* PORT0 PAD MODE CTRL */
                        0x58 0xffb7ffb7 /* LED_CTRL2 */
                        0x5c 0x03ffff00 /* LED_CTRL3 */
                        0x7c 0x0000007e /* PORT0_STATUS */
                >;
        };
};

&eth0 {
        status = "okay";

        /* default for ar934x, except for 1000M and 10M */
        pll-data = <0x06000000 0x00000101 0x00001313>;

        mtd-mac-address = <&eeprom 0x0>;

        phy-mode = "rgmii";
        phy-handle = <&phy0>;

        gmac-config {
                device = <&gmac>;
                rxd-delay = <2>;
                rxdv-delay = <2>;
        };
};

&wmac {
        status = "okay";

        mtd-cal-data = <&eeprom 0x1000>;
        mtd-mac-address = <&eeprom 0x1002>;
};