OpenWrt – Rev 4

Subversion Repositories:
Rev:
// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
/dts-v1/;

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

#include "ar9331.dtsi"

/ {
        model = "eTactica EG200";
        compatible = "etactica,eg200", "qca,ar9331";

        aliases {
                serial0 = &uart;
        };

        keys {
                compatible = "gpio-keys-polled";
                poll-interval = <50>;

                restore {
                        linux,code = <KEY_WPS_BUTTON>;
                        gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
                };
        };

        leds {
                compatible = "gpio-leds";

                modbus {
                        label = "eg200:red:modbus";
                        gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
                };

                etactica {
                        label = "eg200:red:etactica";
                        gpios = <&gpio 15 GPIO_ACTIVE_HIGH>;
                };

                eth0 {
                        label = "eg200:red:eth0";
                        gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
                };

                wlan {
                        label = "eg200:red:wlan";
                        gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
                        linux,default-trigger = "phy0tpt";
                };
        };
};

&uart {
        status = "okay";
};

&gpio {
        status = "okay";
};

&usb {
        dr_mode = "host";
        status = "okay";
};

&usb_phy {
        status = "okay";
};

&eth0 {
        status = "okay";
        mtd-mac-address = <&art 0x0>;

        gmac-config {
                device = <&gmac>;
                switch-phy-addr-swap = <1>;
                switch-phy-swap = <1>;
        };
};

&eth1 {
        status = "okay";
        compatible = "syscon", "simple-mfd";
};

&spi {
        num-chipselects = <1>;
        status = "okay";

        flash@0 {
                compatible = "jedec,spi-nor";
                spi-max-frequency = <50000000>;
                reg = <0>;

                partitions {
                        compatible = "fixed-partitions";
                        #address-cells = <1>;
                        #size-cells = <1>;

                        uboot@0 {
                                reg = <0x0 0x40000>;
                                read-only;
                        };

                        uboot-env@40000 {
                                reg = <0x40000 0x10000>;
                                read-only;
                        };

                        firmware@50000 {
                                compatible = "denx,uimage";
                                reg = <0x50000 0xfa0000>;
                        };

                        art: art@ff0000 {
                                reg = <0xff0000 0x10000>;
                                read-only;
                        };
                };
        };
};

&wmac {
        status = "okay";
        mtd-cal-data = <&art 0x1000>;
        mtd-mac-address = <&art 0x1002>;
};