OpenWrt – Rev 4
?pathlinks?
--- a/arch/powerpc/platforms/4xx/pci.c
+++ b/arch/powerpc/platforms/4xx/pci.c
@@ -1060,15 +1060,24 @@ static int __init apm821xx_pciex_init_po
u32 val;
/*
- * Do a software reset on PCIe ports.
- * This code is to fix the issue that pci drivers doesn't re-assign
- * bus number for PCIE devices after Uboot
- * scanned and configured all the buses (eg. PCIE NIC IntelPro/1000
- * PT quad port, SAS LSI 1064E)
+ * Only reset the PHY when no link is currently established.
+ * This is for the Atheros PCIe board which has problems to establish
+ * the link (again) after this PHY reset. All other currently tested
+ * PCIe boards don't show this problem.
*/
-
- mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x0);
- mdelay(10);
+ val = mfdcri(SDR0, port->sdr_base + PESDRn_LOOP);
+ if (!(val & 0x00001000)) {
+ /*
+ * Do a software reset on PCIe ports.
+ * This code is to fix the issue that pci drivers doesn't re-assign
+ * bus number for PCIE devices after Uboot
+ * scanned and configured all the buses (eg. PCIE NIC IntelPro/1000
+ * PT quad port, SAS LSI 1064E)
+ */
+
+ mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x0);
+ mdelay(10);
+ }
if (port->endpoint)
val = PTYPE_LEGACY_ENDPOINT << 20;
@@ -1085,9 +1094,12 @@ static int __init apm821xx_pciex_init_po
mtdcri(SDR0, PESDR0_460EX_L0DRV, 0x00000130);
mtdcri(SDR0, PESDR0_460EX_L0CLK, 0x00000006);
- mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x10000000);
- mdelay(50);
- mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x30000000);
+ val = mfdcri(SDR0, port->sdr_base + PESDRn_LOOP);
+ if (!(val & 0x00001000)) {
+ mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x10000000);
+ mdelay(50);
+ mtdcri(SDR0, PESDR0_460EX_PHY_CTL_RST, 0x30000000);
+ }
mtdcri(SDR0, port->sdr_base + PESDRn_RCSSET,
mfdcri(SDR0, port->sdr_base + PESDRn_RCSSET) |