OpenWrt – Rev 4

Subversion Repositories:
Rev:
/dts-v1/;

#include "mt7628an.dtsi"

#include <dt-bindings/gpio/gpio.h>
#include <dt-bindings/input/input.h>

/{
        compatible = "glinet,gl-mt300n-v3", "mediatek,mt7628an-soc";
        model = "GL-MT300N-V3";

        chosen {
                bootargs = "console=ttyS0,115200";
        };

        memory@0 {
                device_type = "memory";
                reg = <0x0 0x4000000>;
        };

        gpio-leds {
                compatible = "gpio-leds";

                power {
                        label = "gl-mt300n-v3:blue:power";
                        default-state = "on";
                        gpios = <&gpio1 10 GPIO_ACTIVE_LOW>;
                };

                wlan {
                        label = "gl-mt300n-v3:white:wlan";
                        gpios = <&gpio1 12 GPIO_ACTIVE_LOW>;
                };
        };

        gpio-keys-polled {
                compatible = "gpio-keys-polled";
                #address-cells = <1>;
                #size-cells = <0>;
                poll-interval = <20>;

                reset {
                        label = "reset";
                        gpios = <&gpio1 6 GPIO_ACTIVE_LOW>;
                        linux,code = <KEY_RESTART>;
                };
        };
};

&pinctrl {
        state_default: pinctrl0 {
                gpio {
                        ralink,group = "wdt", "wled_an", "p1led_an";
                        ralink,function = "gpio";
                };
        };
};

&ethernet {
        mtd-mac-address = <&factory 0x4>;
};

&wmac {
        status = "okay";
        ralink,mtd-eeprom = <&factory 0x4>;
};

&spi0 {
        status = "okay";

        m25p80@0 {
                #address-cells = <1>;
                #size-cells = <1>;
                compatible = "jedec,spi-nor";
                reg = <0>;
                spi-max-frequency = <10000000>;
                m25p,chunked-io = <32>;

                partition@0 {
                        label = "u-boot";
                        reg = <0x0 0x30000>;
                        read-only;
                };

                partition@30000 {
                        label = "u-boot-env";
                        reg = <0x30000 0x10000>;
                        read-only;
                };

                factory: partition@40000 {
                         label = "factory";
                         reg = <0x40000 0x10000>;
                         read-only;
                };

                partition@50000 {
                         label = "firmware";
                         reg = <0x50000 0x7b0000>;
                };
        };
};

&uart1 {
        status = "okay";
};