OpenWrt – Rev 4

Subversion Repositories:
Rev:
--- a/arch/arm/boot/dts/kirkwood-linksys-viper.dts
+++ b/arch/arm/boot/dts/kirkwood-linksys-viper.dts
@@ -69,6 +69,17 @@
                };
        };
 
+       mvsw61xx {
+               compatible = "marvell,88e6171";
+               status = "okay";
+               reg = <0x10>;
+
+               mii-bus = <&mdio>;
+               cpu-port-0 = <5>;
+               cpu-port-1 = <6>;
+               is-indirect;
+       };
+
        dsa {
                compatible = "marvell,dsa";
                #address-cells = <2>;
@@ -161,22 +172,22 @@
                };
 
                partition@200000 {
-                       label = "kernel";
+                       label = "kernel1";
                        reg = <0x200000 0x2A0000>;
                };
 
                partition@4A0000 {
-                       label = "rootfs";
+                       label = "rootfs1";
                        reg = <0x4A0000 0x1760000>;
                };
 
                partition@1C00000 {
-                       label = "alt_kernel";
+                       label = "kernel2";
                        reg = <0x1C00000 0x2A0000>;
                };
 
                partition@1EA0000 {
-                       label = "alt_rootfs";
+                       label = "rootfs2";
                        reg = <0x1EA0000 0x1760000>;
                };
 
@@ -225,10 +236,14 @@
 };
 
 /* eth1 is connected to the switch at port 6. However DSA only supports a
- * single CPU port. So leave this port disabled to avoid confusion.
+ * single CPU port. Upstream uses DSA so they disable this port to avoid confusion.
  */
 &eth1 {
-       status = "disabled";
+       status = "okay";
+       ethernet1-port@0 {
+               speed = <1000>;
+               duplex = <1>;
+       };
 };
 
 /* There is no battery on the board, so the RTC does not keep