OpenWrt
/branches/18.06.1/target/linux/ramips/dts/MT7620a_V22SG.dts/MT7620a_V22SG.dts |
@@ -0,0 +1,120 @@ |
/dts-v1/; |
|
#include "mt7620a.dtsi" |
|
#include <dt-bindings/gpio/gpio.h> |
#include <dt-bindings/input/input.h> |
|
/ { |
compatible = "ralink,mt7620a-eval-board", "ralink,mt7620a-soc"; |
model = "Ralink MT7620a V22SG High Power evaluation board"; |
|
keys { |
compatible = "gpio-keys-polled"; |
poll-interval = <20>; |
|
reset { |
label = "reset"; |
gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_RESTART>; |
}; |
|
aoss { |
label = "aoss"; |
gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_WPS_BUTTON>; |
}; |
}; |
|
nand { |
compatible = "mtk,mt7620-nand"; |
|
partitions { |
compatible = "fixed-partitions"; |
#address-cells = <1>; |
#size-cells = <1>; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x40000>; |
read-only; |
}; |
|
partition@40000 { |
label = "u-boot-env"; |
reg = <0x40000 0x20000>; |
read-only; |
}; |
|
factory: partition@60000 { |
label = "factory"; |
reg = <0x60000 0x20000>; |
read-only; |
}; |
|
partition@80000 { |
compatible = "denx,uimage"; |
label = "firmware"; |
reg = <0x80000 0x7f80000>; |
}; |
}; |
}; |
}; |
|
&pinctrl { |
state_default: pinctrl0 { |
gpio { |
ralink,group = "i2c", "uartf", "spi"; |
ralink,function = "gpio"; |
}; |
}; |
}; |
|
ðernet { |
status = "okay"; |
pinctrl-names = "default"; |
pinctrl-0 = <&rgmii1_pins &rgmii2_pins &mdio_pins>; |
mediatek,portmap = "llllw"; |
|
port@4 { |
status = "okay"; |
phy-handle = <&phy4>; |
phy-mode = "rgmii"; |
}; |
|
port@5 { |
status = "okay"; |
phy-handle = <&phy5>; |
phy-mode = "rgmii"; |
}; |
|
mdio-bus { |
status = "okay"; |
|
phy4: ethernet-phy@4 { |
reg = <4>; |
phy-mode = "rgmii"; |
}; |
|
phy5: ethernet-phy@5 { |
reg = <5>; |
phy-mode = "rgmii"; |
}; |
}; |
}; |
|
&gsw { |
mediatek,port4 = "gmac"; |
}; |
|
&pcie { |
status = "okay"; |
}; |
|
&ehci { |
status = "okay"; |
}; |
|
&ohci { |
status = "okay"; |
}; |