OpenWrt
| /branches/18.06.1/target/linux/ramips/dts/MT7620a_MT7610e.dts |
|---|
| @@ -0,0 +1,99 @@ |
| /dts-v1/; |
| #include "mt7620a.dtsi" |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/input/input.h> |
| / { |
| compatible = "ralink,mt7620a-eval-board", "ralink,mt7620a-soc"; |
| model = "Ralink MT7620A evaluation board"; |
| keys { |
| compatible = "gpio-keys"; |
| poll-interval = <20>; |
| wps { |
| label = "wps"; |
| gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; |
| linux,code = <BTN_0>; |
| }; |
| reset { |
| label = "reset"; |
| gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; |
| linux,code = <BTN_1>; |
| }; |
| }; |
| }; |
| &gpio0 { |
| status = "okay"; |
| }; |
| &spi0 { |
| status = "okay"; |
| m25p80@0 { |
| compatible = "jedec,spi-nor"; |
| reg = <0>; |
| spi-max-frequency = <1000000>; |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| partition@30000 { |
| label = "u-boot-env"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| factory: partition@40000 { |
| label = "factory"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| partition@50000 { |
| compatible = "denx,uimage"; |
| label = "firmware"; |
| reg = <0x50000 0x7b0000>; |
| }; |
| }; |
| }; |
| }; |
| ðernet { |
| status = "okay"; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&ephy_pins>; |
| mediatek,portmap = "llllw"; |
| }; |
| &gsw { |
| mediatek,port4 = "ephy"; |
| }; |
| &sdhci { |
| status = "okay"; |
| }; |
| &pcie { |
| status = "okay"; |
| }; |
| &pcie0 { |
| wifi@0,0 { |
| reg = <0x0000 0 0 0 0>; |
| mediatek,mtd-eeprom = <&factory 0x8000>; |
| ieee80211-freq-limit = <5000000 6000000>; |
| }; |
| }; |