OpenWrt
/branches/18.06.1/target/linux/ramips/dts/M3.dts |
@@ -0,0 +1,106 @@ |
/dts-v1/; |
|
#include "rt5350.dtsi" |
|
#include <dt-bindings/gpio/gpio.h> |
#include <dt-bindings/input/input.h> |
|
/ { |
compatible = "poray,m3", "ralink,rt5350-soc"; |
model = "Poray M3"; |
|
gpio-leds { |
compatible = "gpio-leds"; |
|
status { |
label = "m3:blue:status"; |
gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
}; |
}; |
|
gpio-keys-polled { |
compatible = "gpio-keys-polled"; |
#address-cells = <1>; |
#size-cells = <0>; |
poll-interval = <20>; |
|
reset { |
label = "reset"; |
gpios = <&gpio0 10 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_RESTART>; |
}; |
|
mode { |
label = "mode"; |
gpios = <&gpio0 17 GPIO_ACTIVE_LOW>; |
linux,code = <BTN_0>; |
linux,input-type = <EV_SW>; |
}; |
}; |
}; |
|
&spi0 { |
status = "okay"; |
|
m25p80@0 { |
#address-cells = <1>; |
#size-cells = <1>; |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
read-only; |
}; |
|
partition@30000 { |
label = "u-boot-env"; |
reg = <0x30000 0x10000>; |
read-only; |
}; |
|
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
|
partition@50000 { |
label = "firmware"; |
reg = <0x50000 0x3b0000>; |
}; |
}; |
}; |
|
&pinctrl { |
state_default: pinctrl0 { |
gpio { |
ralink,group = "i2c", "jtag", "uartf"; |
ralink,function = "gpio"; |
}; |
}; |
}; |
|
ðernet { |
mtd-mac-address = <&factory 0x4>; |
}; |
|
&esw { |
mediatek,portmap = <0x2f>; |
mediatek,led_polarity = <1>; |
}; |
|
&wmac { |
ralink,mtd-eeprom = <&factory 0>; |
ralink,led-polarity = <1>; |
}; |
|
&ehci { |
status = "okay"; |
}; |
|
&ohci { |
status = "okay"; |
}; |