OpenWrt
| /branches/18.06.1/target/linux/ramips/dts/K2P.dts |
|---|
| @@ -9,13 +9,6 @@ |
| compatible = "phicomm,k2p", "mediatek,mt7621-soc"; |
| model = "Phicomm K2P"; |
| aliases { |
| led-boot = &led_blue; |
| led-failsafe = &led_blue; |
| led-running = &led_blue; |
| led-upgrade = &led_blue; |
| }; |
| memory@0 { |
| device_type = "memory"; |
| reg = <0x0 0x8000000>; |
| @@ -25,7 +18,7 @@ |
| bootargs = "console=ttyS0,57600"; |
| }; |
| leds { |
| gpio-leds { |
| compatible = "gpio-leds"; |
| stat_r { |
| @@ -38,14 +31,16 @@ |
| gpios = <&gpio0 14 GPIO_ACTIVE_LOW>; |
| }; |
| led_blue: stat_b { |
| stat_b { |
| label = "k2p:blue:status"; |
| gpios = <&gpio0 15 GPIO_ACTIVE_LOW>; |
| }; |
| }; |
| keys { |
| gpio-keys-polled { |
| compatible = "gpio-keys-polled"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| poll-interval = <20>; |
| reset { |
| @@ -60,44 +55,40 @@ |
| status = "okay"; |
| m25p80@0 { |
| #address-cells = <1>; |
| #size-cells = <1>; |
| compatible = "jedec,spi-nor"; |
| reg = <0>; |
| spi-max-frequency = <10000000>; |
| m25p,chunked-io = <32>; |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| partition@30000 { |
| label = "u-boot-env"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| partition@30000 { |
| label = "u-boot-env"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| factory: partition@40000 { |
| label = "factory"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| factory: partition@40000 { |
| label = "factory"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| partition@50000 { |
| label = "permanent_config"; |
| reg = <0x50000 0x50000>; |
| read-only; |
| }; |
| partition@50000 { |
| label = "permanent_config"; |
| reg = <0x50000 0x50000>; |
| read-only; |
| }; |
| partition@a0000 { |
| compatible = "denx,uimage"; |
| label = "firmware"; |
| reg = <0xa0000 0xf60000>; |
| }; |
| partition@a0000 { |
| label = "firmware"; |
| reg = <0xa0000 0xf60000>; |
| }; |
| }; |
| }; |
| @@ -104,12 +95,13 @@ |
| &pcie { |
| status = "okay"; |
| }; |
| &pcie0 { |
| mt76@0,0 { |
| reg = <0x0000 0 0 0 0>; |
| mediatek,mtd-eeprom = <&factory 0x0>; |
| pcie0 { |
| mt76@0,0 { |
| reg = <0x0000 0 0 0 0>; |
| device_type = "pci"; |
| mediatek,mtd-eeprom = <&factory 0x0>; |
| }; |
| }; |
| }; |