OpenWrt
/branches/18.06.1/target/linux/ramips/dts/GL-MT300A.dts |
@@ -13,7 +13,7 @@ |
bootargs = "console=ttyS0,115200"; |
}; |
|
leds { |
gpio-leds { |
compatible = "gpio-leds"; |
|
wan { |
@@ -35,10 +35,13 @@ |
label = "gl-mt300a:usb"; |
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; |
}; |
|
}; |
|
keys { |
gpio-keys-polled { |
compatible = "gpio-keys-polled"; |
#address-cells = <1>; |
#size-cells = <0>; |
poll-interval = <20>; |
reset { |
label = "reset"; |
@@ -52,12 +55,12 @@ |
linux,code = <BTN_0>; |
}; |
|
BTN_1 { |
BTN_1 { |
label = "BTN_1"; |
gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; |
linux,code = <BTN_1>; |
}; |
}; |
}; |
}; |
|
&gpio0 { |
@@ -71,7 +74,7 @@ |
&gpio2 { |
status = "okay"; |
}; |
|
|
&gpio3 { |
status = "okay"; |
}; |
@@ -80,42 +83,37 @@ |
status = "okay"; |
|
m25p80@0 { |
#address-cells = <1>; |
#size-cells = <1>; |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partitions { |
compatible = "fixed-partitions"; |
#address-cells = <1>; |
#size-cells = <1>; |
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
}; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
}; |
partition@30000 { |
label = "u-boot-env"; |
reg = <0x30000 0x10000>; |
read-only; |
}; |
|
partition@30000 { |
label = "u-boot-env"; |
reg = <0x30000 0x10000>; |
read-only; |
}; |
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
|
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
partition@50000 { |
label = "firmware"; |
reg = <0x50000 0xf80000>; |
}; |
|
partition@50000 { |
compatible = "denx,uimage"; |
label = "firmware"; |
reg = <0x50000 0xf80000>; |
}; |
|
partition@ff0000 { |
label = "art"; |
reg = <0xff0000 0x10000>; |
}; |
partition@ff0000 { |
label = "art"; |
reg = <0xff0000 0x10000>; |
}; |
}; |
}; |