| /branches/18.06.1/target/linux/ramips/dts/F5D8235_V2.dts |
|---|
| @@ -0,0 +1,146 @@ |
|---|
| /dts-v1/; |
| |
| #include "rt3050.dtsi" |
| |
| #include <dt-bindings/gpio/gpio.h> |
| #include <dt-bindings/input/input.h> |
| |
| / { |
| compatible = "belkin,f5d8235-v2", "ralink,rt3052-soc"; |
| model = "Belkin F5D8235 v2"; |
| |
| aliases { |
| led-boot = &led_router; |
| led-failsafe = &led_router; |
| led-running = &led_router; |
| led-upgrade = &led_router; |
| }; |
| |
| cfi@1f000000 { |
| compatible = "cfi-flash"; |
| reg = <0x1f000000 0x800000>; |
| bank-width = <2>; |
| device-width = <2>; |
| |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| |
| uboot: partition@0 { |
| label = "uboot"; |
| reg = <0x0 0x50000>; |
| read-only; |
| }; |
| |
| partition@50000 { |
| compatible = "denx,uimage"; |
| label = "firmware"; |
| reg = <0x50000 0x790000>; |
| }; |
| |
| partition@7e0000 { |
| label = "nvram"; |
| reg = <0x7e0000 0x10000>; |
| }; |
| |
| factory: partition@7f0000 { |
| label = "factory"; |
| reg = <0x7f0000 0x10000>; |
| }; |
| }; |
| }; |
| |
| rtl8366rb { |
| compatible = "realtek,rtl8366rb"; |
| gpio-sda = <&gpio0 1 GPIO_ACTIVE_HIGH>; |
| gpio-sck = <&gpio0 2 GPIO_ACTIVE_HIGH>; |
| }; |
| |
| leds { |
| compatible = "gpio-leds"; |
| |
| internet { |
| label = "f5d8235-v2:blue:internet"; |
| gpios = <&gpio0 5 GPIO_ACTIVE_LOW>; |
| }; |
| |
| internet2 { |
| label = "f5d8235-v2:amber:internet"; |
| gpios = <&gpio0 6 GPIO_ACTIVE_LOW>; |
| }; |
| |
| modem { |
| label = "f5d8235-v2:blue:modem"; |
| gpios = <&gpio0 11 GPIO_ACTIVE_LOW>; |
| }; |
| |
| modem2 { |
| label = "f5d8235-v2:amber:modem"; |
| gpios = <&gpio0 8 GPIO_ACTIVE_LOW>; |
| }; |
| |
| led_router: router { |
| label = "f5d8235-v2:blue:router"; |
| gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
| }; |
| |
| storage { |
| label = "f5d8235-v2:blue:storage"; |
| gpios = <&gpio0 23 GPIO_ACTIVE_LOW>; |
| trigger-sources = <&otg_port1>; |
| linux,default-trigger = "usbport"; |
| }; |
| |
| storage2 { |
| label = "f5d8235-v2:amber:storage"; |
| gpios = <&gpio0 22 GPIO_ACTIVE_LOW>; |
| }; |
| |
| security { |
| label = "f5d8235-v2:blue:security"; |
| gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; |
| }; |
| |
| security2 { |
| label = "f5d8235-v2:amber:security"; |
| gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; |
| }; |
| }; |
| }; |
| |
| &pinctrl { |
| state_default: pinctrl0 { |
| gpio { |
| ralink,group = "spi", "i2c", "jtag", "mdio", "uartf"; |
| ralink,function = "gpio"; |
| }; |
| }; |
| }; |
| |
| ðernet { |
| mtd-mac-address = <&uboot 0x40004>; |
| pinctrl-names = "default"; |
| pinctrl-0 = <&rgmii_pins>; |
| }; |
| |
| &esw { |
| ralink,rgmii = <1>; |
| mediatek,portmap = <0x3f>; |
| ralink,fct2 = <0x0002500c>; |
| /* |
| * ext phy base addr 31, rx/tx clock skew 0, |
| * turbo mii off, rgmi 3.3v off, port 5 polling off |
| * port5: enabled, gige, full-duplex, rx/tx-flow-control |
| * port6: enabled, gige, full-duplex, rx/tx-flow-control |
| */ |
| ralink,fpa2 = <0x1f003fff>; |
| }; |
| |
| &wmac { |
| ralink,mtd-eeprom = <&uboot 0x40000>; |
| }; |
| |
| &otg { |
| status = "okay"; |
| }; |
