/branches/18.06.1/target/linux/ramips/dts/EX3700.dts |
@@ -0,0 +1,162 @@ |
/* This file is released into the public domain */ |
|
/dts-v1/; |
|
#include <dt-bindings/gpio/gpio.h> |
#include <dt-bindings/input/input.h> |
|
#include "mt7620a.dtsi" |
|
/ { |
compatible = "netgear,ex3700", "ralink,mt7620a-soc"; |
model = "Netgear EX3700/EX3800"; |
|
chosen { |
bootargs = "console=ttyS0,57600"; |
}; |
|
gpio-leds { |
compatible = "gpio-leds"; |
|
power_g { |
label = "ex3700:green:power"; |
gpios = <&gpio2 23 GPIO_ACTIVE_LOW>; |
default-state = "on"; |
}; |
|
power_a { |
label = "ex3700:amber:power"; |
gpios = <&gpio2 28 GPIO_ACTIVE_LOW>; |
default-state = "off"; |
}; |
|
router_g { |
label = "ex3700:green:router"; |
gpios = <&gpio2 25 GPIO_ACTIVE_LOW>; |
}; |
|
router_r { |
label = "ex3700:red:router"; |
gpios = <&gpio2 24 GPIO_ACTIVE_LOW>; |
}; |
|
device_g { |
label = "ex3700:green:device"; |
gpios = <&gpio2 20 GPIO_ACTIVE_LOW>; |
}; |
|
device_r { |
label = "ex3700:red:device"; |
gpios = <&gpio2 21 GPIO_ACTIVE_LOW>; |
}; |
|
wps { |
label = "ex3700:green:wps"; |
gpios = <&gpio2 27 GPIO_ACTIVE_LOW>; |
}; |
}; |
|
gpio-keys-polled { |
compatible = "gpio-keys-polled"; |
#address-cells = <1>; |
#size-cells = <0>; |
poll-interval = <20>; |
|
reset { |
label = "reset"; |
gpios = <&gpio2 26 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_RESTART>; |
}; |
|
wps { |
label = "wps"; |
gpios = <&gpio0 2 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_WPS_BUTTON>; |
}; |
}; |
}; |
|
&gpio0 { |
status = "okay"; |
}; |
|
&gpio2 { |
status = "okay"; |
}; |
|
&spi0 { |
status = "okay"; |
|
m25p80@0 { |
#address-cells = <1>; |
#size-cells = <1>; |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
read-only; |
}; |
|
partition@30000 { |
label = "config"; |
reg = <0x30000 0x10000>; |
read-only; |
}; |
|
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
|
partition@50000 { |
label = "firmware"; |
reg = <0x50000 0x790000>; |
}; |
|
partition@7e0000 { |
label = "board_data"; |
reg = <0x7e0000 0x10000>; |
read-only; |
}; |
|
partition@7f0000 { |
label = "nvram"; |
reg = <0x7f0000 0x10000>; |
read-only; |
}; |
}; |
}; |
|
&pcie { |
status = "okay"; |
|
pcie-bridge { |
mt76@0,0 { |
reg = <0x0000 0 0 0 0 >; |
device_type = "pci"; |
mediatek,mtd-eeprom = <&factory 0x8000>; |
ieee80211-freq-limit = <5000000 6000000>; |
}; |
}; |
}; |
|
ðernet { |
mtd-mac-address = <&factory 0x28>; |
}; |
|
&wmac { |
ralink,mtd-eeprom = <&factory 0x0>; |
}; |
|
&pinctrl { |
state_default: pinctrl0 { |
default { |
ralink,group = "i2c", "rgmii2", "spi refclk"; |
ralink,function = "gpio"; |
}; |
}; |
}; |