OpenWrt
| /branches/18.06.1/target/linux/ramips/dts/DIR-300-B1.dts |
|---|
| @@ -9,52 +9,42 @@ |
| compatible = "dlink,dir-300-b1", "ralink,rt3050-soc"; |
| model = "D-Link DIR-300 B1"; |
| aliases { |
| led-boot = &led_status_green; |
| led-failsafe = &led_status_green; |
| led-running = &led_status_green; |
| led-upgrade = &led_status_green; |
| }; |
| cfi@1f000000 { |
| compatible = "cfi-flash"; |
| reg = <0x1f000000 0x800000>; |
| bank-width = <2>; |
| device-width = <2>; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| partitions { |
| compatible = "fixed-partitions"; |
| #address-cells = <1>; |
| #size-cells = <1>; |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| partition@0 { |
| label = "u-boot"; |
| reg = <0x0 0x30000>; |
| read-only; |
| }; |
| devdata: partition@30000 { |
| label = "devdata"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| devdata: partition@30000 { |
| label = "devdata"; |
| reg = <0x30000 0x10000>; |
| read-only; |
| }; |
| factory: partition@40000 { |
| label = "devconf"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| factory: partition@40000 { |
| label = "devconf"; |
| reg = <0x40000 0x10000>; |
| read-only; |
| }; |
| partition@50000 { |
| compatible = "denx,uimage"; |
| label = "firmware"; |
| reg = <0x50000 0x3b0000>; |
| }; |
| partition@50000 { |
| label = "firmware"; |
| reg = <0x50000 0x3b0000>; |
| }; |
| }; |
| keys { |
| gpio-keys-polled { |
| compatible = "gpio-keys-polled"; |
| #address-cells = <1>; |
| #size-cells = <0>; |
| poll-interval = <20>; |
| reset { |
| @@ -70,7 +60,7 @@ |
| }; |
| }; |
| leds { |
| gpio-leds { |
| compatible = "gpio-leds"; |
| status { |
| @@ -78,7 +68,7 @@ |
| gpios = <&gpio0 8 GPIO_ACTIVE_LOW>; |
| }; |
| led_status_green: status2 { |
| status2 { |
| label = "dir-300-b1:green:status"; |
| gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
| }; |