/branches/18.06.1/target/linux/ramips/dts/ArcherC50.dts/ArcherC50.dts |
@@ -9,18 +9,11 @@ |
compatible = "tplink,c50", "ralink,mt7620a-soc"; |
model = "TP-Link Archer C50"; |
|
aliases { |
led-boot = &led_power; |
led-failsafe = &led_power; |
led-running = &led_power; |
led-upgrade = &led_power; |
}; |
|
chosen { |
bootargs = "console=ttyS0,115200"; |
}; |
|
leds { |
gpio-leds { |
compatible = "gpio-leds"; |
|
lan { |
@@ -28,7 +21,7 @@ |
gpios = <&gpio0 1 GPIO_ACTIVE_LOW>; |
}; |
|
led_power: power { |
power { |
label = "c50:green:power"; |
gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; |
default-state = "on"; |
@@ -37,8 +30,6 @@ |
usb { |
label = "c50:green:usb"; |
gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
trigger-sources = <&ohci_port1>, <&ehci_port1>; |
linux,default-trigger = "usbport"; |
}; |
|
wan { |
@@ -67,8 +58,10 @@ |
}; |
}; |
|
keys { |
gpio-keys-polled { |
compatible = "gpio-keys-polled"; |
#address-cells = <1>; |
#size-cells = <0>; |
poll-interval = <20>; |
|
reset { |
@@ -100,50 +93,45 @@ |
status = "okay"; |
|
m25p80@0 { |
#address-cells = <1>; |
#size-cells = <1>; |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partitions { |
compatible = "fixed-partitions"; |
#address-cells = <1>; |
#size-cells = <1>; |
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x20000>; |
read-only; |
}; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x20000>; |
read-only; |
}; |
partition@20000 { |
label = "firmware"; |
reg = <0x20000 0x7a0000>; |
}; |
|
partition@20000 { |
compatible = "tplink,firmware"; |
label = "firmware"; |
reg = <0x20000 0x7a0000>; |
}; |
partition@7c0000 { |
label = "config"; |
reg = <0x7c0000 0x10000>; |
read-only; |
}; |
|
partition@7c0000 { |
label = "config"; |
reg = <0x7c0000 0x10000>; |
read-only; |
}; |
rom: partition@7d0000 { |
label = "rom"; |
reg = <0x7d0000 0x10000>; |
read-only; |
}; |
|
rom: partition@7d0000 { |
label = "rom"; |
reg = <0x7d0000 0x10000>; |
read-only; |
}; |
partition@7e0000 { |
label = "romfile"; |
reg = <0x7e0000 0x10000>; |
read-only; |
}; |
|
partition@7e0000 { |
label = "romfile"; |
reg = <0x7e0000 0x10000>; |
read-only; |
}; |
|
radio: partition@7f0000 { |
label = "radio"; |
reg = <0x7f0000 0x10000>; |
read-only; |
}; |
radio: partition@7f0000 { |
label = "radio"; |
reg = <0x7f0000 0x10000>; |
read-only; |
}; |
}; |
}; |
@@ -185,14 +173,15 @@ |
|
&pcie { |
status = "okay"; |
}; |
|
&pcie0 { |
mt76@0,0 { |
reg = <0x0000 0 0 0 0>; |
mediatek,mtd-eeprom = <&radio 32768>; |
ieee80211-freq-limit = <5000000 6000000>; |
mtd-mac-address = <&rom 0xf100>; |
mtd-mac-address-increment = <(-1)>; |
pcie-bridge { |
mt76@0,0 { |
reg = <0x0000 0 0 0 0>; |
device_type = "pci"; |
mediatek,mtd-eeprom = <&radio 32768>; |
ieee80211-freq-limit = <5000000 6000000>; |
mtd-mac-address = <&rom 0xf100>; |
mtd-mac-address-increment = <(-1)>; |
}; |
}; |
}; |