/branches/18.06.1/target/linux/ramips/dts/AWUSFREE1.dts |
@@ -0,0 +1,173 @@ |
/* |
* BSD LICENSE |
* |
* Copyright (C) 2018 Piotr Dymacz <pepe2k@gmail.com> |
* All rights reserved. |
* |
* Redistribution and use in source and binary forms, with or without |
* modification, are permitted provided that the following conditions |
* are met: |
* |
* 1. Redistributions of source code must retain the above copyright |
* notice, this list of conditions and the following disclaimer. |
* 2. Redistributions in binary form must reproduce the above copyright |
* notice, this list of conditions and the following disclaimer in the |
* documentation and/or other materials provided with the distribution. |
* 3. Neither the names of the copyright holders nor the names of any |
* contributors may be used to endorse or promote products derived |
* from this software without specific prior written permission. |
* |
* THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS |
* "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT |
* LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR |
* A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT |
* HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, |
* SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT |
* LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, |
* DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY |
* THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT |
* (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE |
* OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. |
*/ |
|
/dts-v1/; |
|
#include "mt7628an.dtsi" |
|
#include <dt-bindings/gpio/gpio.h> |
#include <dt-bindings/input/input.h> |
|
/ { |
compatible = "alfa-network,awusfree1", "mediatek,mt7628an-soc"; |
model = "ALFA Network AWUSFREE1"; |
|
aliases { |
led-boot = &led_system; |
led-failsafe = &led_system; |
led-running = &led_system; |
led-upgrade = &led_system; |
}; |
|
chosen { |
bootargs = "console=ttyS0,115200"; |
}; |
|
keys { |
compatible = "gpio-keys-polled"; |
poll-interval = <20>; |
|
reset { |
label = "reset"; |
gpios = <&gpio1 6 GPIO_ACTIVE_LOW>; |
linux,code = <KEY_RESTART>; |
}; |
}; |
|
leds { |
compatible = "gpio-leds"; |
|
led_system: system { |
label = "awusfree1:orange:system"; |
gpios = <&gpio1 11 GPIO_ACTIVE_LOW>; |
}; |
|
wlan { |
label = "awusfree1:blue:wlan"; |
gpios = <&gpio1 12 GPIO_ACTIVE_LOW>; |
}; |
}; |
|
memory@0 { |
device_type = "memory"; |
reg = <0x0 0x4000000>; |
}; |
}; |
|
&ehci { |
status = "disabled"; |
}; |
|
&esw { |
mediatek,portdisable = <0x1e>; |
}; |
|
ðernet { |
mtd-mac-address = <&factory 0x2e>; |
}; |
|
&gpio1 { |
status = "okay"; |
}; |
|
&ohci { |
status = "disabled"; |
}; |
|
&pinctrl { |
state_default: pinctrl0 { |
gpio { |
ralink,group = "p0led_an", "wdt", "wled_an"; |
ralink,function = "gpio"; |
}; |
|
ext_lna { |
ralink,group = "uart1"; |
ralink,function = "sw_r"; |
}; |
|
ext_pa { |
ralink,group = "i2s"; |
ralink,function = "antenna"; |
}; |
}; |
}; |
|
&spi0 { |
status = "okay"; |
|
m25p80@0 { |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partitions { |
compatible = "fixed-partitions"; |
#address-cells = <1>; |
#size-cells = <1>; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
read-only; |
}; |
|
partition@30000 { |
label = "u-boot-env"; |
reg = <0x30000 0x1000>; |
}; |
|
partition@31000 { |
label = "config"; |
reg = <0x31000 0xf000>; |
read-only; |
}; |
|
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
|
partition@50000 { |
compatible = "denx,uimage"; |
label = "firmware"; |
reg = <0x50000 0x7b0000>; |
}; |
}; |
}; |
}; |
|
&wmac { |
status = "okay"; |
mediatek,mtd-eeprom = <&factory 0x0>; |
}; |