/branches/18.06.1/target/linux/ramips/dts/ALL5002.dts |
@@ -0,0 +1,119 @@ |
/dts-v1/; |
|
#include "rt3352.dtsi" |
|
#include <dt-bindings/gpio/gpio.h> |
#include <dt-bindings/input/input.h> |
|
/ { |
compatible = "allnet,all5002", "ralink,rt3352-soc"; |
model = "Allnet ALL5002"; |
|
i2c-gpio { |
#address-cells = <1>; |
#size-cells = <0>; |
|
compatible = "i2c-gpio"; |
gpios = <&gpio0 1 GPIO_ACTIVE_HIGH &gpio0 2 GPIO_ACTIVE_HIGH>; |
i2c-gpio,delay-us = <10>; |
|
pcf0: iexp@38 { |
#gpio-cells = <2>; |
compatible = "inxp,pcf8574a"; |
reg = <0x38>; |
gpio-controller; |
}; |
|
hwmon@4b { |
compatible = "national,lm92"; |
reg = <0x4b>; |
}; |
}; |
|
leds { |
compatible = "gpio-leds"; |
|
ld1 { |
label = "all5002:green:ld1"; |
gpios = <&pcf0 0 GPIO_ACTIVE_LOW>; |
}; |
|
ld2 { |
label = "all5002:green:ld2"; |
gpios = <&pcf0 1 GPIO_ACTIVE_LOW>; |
}; |
}; |
}; |
|
&gpio0 { |
status = "okay"; |
}; |
|
&spi0 { |
status = "okay"; |
|
m25p80@0 { |
compatible = "jedec,spi-nor"; |
reg = <0>; |
spi-max-frequency = <10000000>; |
|
partitions { |
compatible = "fixed-partitions"; |
#address-cells = <1>; |
#size-cells = <1>; |
|
partition@0 { |
label = "u-boot"; |
reg = <0x0 0x30000>; |
read-only; |
}; |
|
partition@30000 { |
label = "u-boot-env"; |
reg = <0x30000 0x10000>; |
read-only; |
}; |
|
factory: partition@40000 { |
label = "factory"; |
reg = <0x40000 0x10000>; |
read-only; |
}; |
|
partition@50000 { |
compatible = "denx,uimage"; |
label = "firmware"; |
reg = <0x50000 0x1fb0000>; |
}; |
}; |
}; |
}; |
|
&pinctrl { |
state_default: pinctrl0 { |
gpio { |
ralink,group = "i2c", "jtag", "rgmii", "mdio", "uartf"; |
ralink,function = "gpio"; |
}; |
}; |
}; |
|
ðernet { |
mtd-mac-address = <&factory 0x28>; |
}; |
|
&esw { |
mediatek,portmap = <0x3f>; |
}; |
|
&wmac { |
ralink,mtd-eeprom = <&factory 0>; |
}; |
|
&ehci { |
status = "okay"; |
}; |
|
&ohci { |
status = "okay"; |
}; |