OpenWrt – Blame information for rev 1
?pathlinks?
Rev | Author | Line No. | Line |
---|---|---|---|
1 | office | 1 | // SPDX-License-Identifier: GPL-2.0-or-later OR MIT |
2 | /dts-v1/; |
||
3 | |||
4 | #include <dt-bindings/gpio/gpio.h> |
||
5 | #include <dt-bindings/input/input.h> |
||
6 | |||
7 | #include "qca9563_elecom_wrc-ghbk2-i.dtsi" |
||
8 | |||
9 | / { |
||
10 | model = "ELECOM WRC-1750GHBK2-I/C"; |
||
11 | compatible = "elecom,wrc-1750ghbk2-i", "qca,qca9563"; |
||
12 | }; |
||
13 | |||
14 | &leds { |
||
15 | power: power { |
||
16 | label = "elecom:blue:power"; |
||
17 | gpios = <&gpio 1 GPIO_ACTIVE_HIGH>; |
||
18 | default-state = "on"; |
||
19 | }; |
||
20 | |||
21 | wlan2g { |
||
22 | label = "elecom:blue:wlan2g"; |
||
23 | gpios = <&gpio 7 GPIO_ACTIVE_HIGH>; |
||
24 | linux,default-trigger = "phy1tpt"; |
||
25 | }; |
||
26 | |||
27 | wlan5g { |
||
28 | label = "elecom:blue:wlan5g"; |
||
29 | gpios = <&gpio 8 GPIO_ACTIVE_HIGH>; |
||
30 | linux,default-trigger = "phy0tpt"; |
||
31 | }; |
||
32 | }; |
||
33 | |||
34 | &partitions { |
||
35 | partition@70000 { |
||
36 | compatible = "denx,uimage"; |
||
37 | label = "firmware"; |
||
38 | reg = <0x070000 0xf70000>; |
||
39 | }; |
||
40 | |||
41 | partition@fe0000 { |
||
42 | label = "hwconfig"; |
||
43 | reg = <0xfe0000 0x010000>; |
||
44 | read-only; |
||
45 | }; |
||
46 | |||
47 | ART: partition@ff0000 { |
||
48 | label = "ART"; |
||
49 | reg = <0xff0000 0x010000>; |
||
50 | read-only; |
||
51 | }; |
||
52 | }; |
||
53 | |||
54 | &pcie { |
||
55 | status = "okay"; |
||
56 | }; |