OpenWrt – Blame information for rev 4
?pathlinks?
| Rev | Author | Line No. | Line |
|---|---|---|---|
| 4 | office | 1 | /dts-v1/; |
| 2 | |||
| 3 | #include <dt-bindings/gpio/gpio.h> |
||
| 4 | |||
| 5 | #include "falcon.dtsi" |
||
| 6 | #include "falcon-sflash-16M.dtsi" |
||
| 7 | |||
| 8 | / { |
||
| 9 | model = "Lantiq Falcon / Vinax MDU Board"; |
||
| 10 | compatible = "lantiq,falcon-mdu", "lantiq,falcon"; |
||
| 11 | |||
| 12 | aliases { |
||
| 13 | spi0 = &ebu_cs0; |
||
| 14 | }; |
||
| 15 | |||
| 16 | memory@0 { |
||
| 17 | device_type = "memory"; |
||
| 18 | reg = <0x0 0x4000000>; // 64M at 0x0 |
||
| 19 | }; |
||
| 20 | |||
| 21 | mdu-leds { |
||
| 22 | compatible = "gpio-leds"; |
||
| 23 | pinctrl-names = "default"; |
||
| 24 | pinctrl-0 = <&bootled_pins>; |
||
| 25 | |||
| 26 | LED_0 { |
||
| 27 | label = "mdu:green:gpon"; |
||
| 28 | gpios = <&gpio0 9 GPIO_ACTIVE_HIGH>; |
||
| 29 | default-state = "keep"; |
||
| 30 | }; |
||
| 31 | LED_1 { |
||
| 32 | label = "mdu:green:status"; |
||
| 33 | gpios = <&gpio0 10 GPIO_ACTIVE_HIGH>; |
||
| 34 | default-state = "keep"; |
||
| 35 | }; |
||
| 36 | LED_2 { |
||
| 37 | label = "mdu:green:2"; |
||
| 38 | gpios = <&gpio0 11 GPIO_ACTIVE_HIGH>; |
||
| 39 | default-state = "keep"; |
||
| 40 | }; |
||
| 41 | LED_3 { |
||
| 42 | label = "mdu:green:3"; |
||
| 43 | gpios = <&gpio0 12 GPIO_ACTIVE_HIGH>; |
||
| 44 | default-state = "keep"; |
||
| 45 | }; |
||
| 46 | LED_4 { |
||
| 47 | label = "mdu:green:4"; |
||
| 48 | gpios = <&gpio0 13 GPIO_ACTIVE_HIGH>; |
||
| 49 | default-state = "keep"; |
||
| 50 | }; |
||
| 51 | }; |
||
| 52 | }; |
||
| 53 |