OpenWrt – Blame information for rev 4
?pathlinks?
| Rev | Author | Line No. | Line |
|---|---|---|---|
| 4 | office | 1 | --- a/drivers/i2c/busses/Kconfig |
| 2 | +++ b/drivers/i2c/busses/Kconfig |
||
| 3 | @@ -473,6 +473,18 @@ config I2C_CBUS_GPIO |
||
| 4 | This driver can also be built as a module. If so, the module |
||
| 5 | will be called i2c-cbus-gpio. |
||
| 6 | |||
| 7 | +config I2C_CNS3XXX |
||
| 8 | + tristate "Cavium CNS3xxx I2C driver" |
||
| 9 | + depends on ARCH_CNS3XXX |
||
| 10 | + help |
||
| 11 | + Support for Cavium CNS3xxx I2C controller driver. |
||
| 12 | + |
||
| 13 | + This driver can also be built as a module. If so, the module |
||
| 14 | + will be called i2c-cns3xxx. |
||
| 15 | + |
||
| 16 | + Please note that this driver might be needed to bring up other |
||
| 17 | + devices such as Cavium CNS3xxx Ethernet. |
||
| 18 | + |
||
| 19 | config I2C_CPM |
||
| 20 | tristate "Freescale CPM1 or CPM2 (MPC8xx/826x)" |
||
| 21 | depends on CPM1 || CPM2 |
||
| 22 | --- a/drivers/i2c/busses/Makefile |
||
| 23 | +++ b/drivers/i2c/busses/Makefile |
||
| 24 | @@ -128,6 +128,7 @@ obj-$(CONFIG_I2C_VIPERBOARD) += i2c-vipe |
||
| 25 | obj-$(CONFIG_I2C_ACORN) += i2c-acorn.o |
||
| 26 | obj-$(CONFIG_I2C_BCM_KONA) += i2c-bcm-kona.o |
||
| 27 | obj-$(CONFIG_I2C_BRCMSTB) += i2c-brcmstb.o |
||
| 28 | +obj-$(CONFIG_I2C_CNS3XXX) += i2c-cns3xxx.o |
||
| 29 | obj-$(CONFIG_I2C_CROS_EC_TUNNEL) += i2c-cros-ec-tunnel.o |
||
| 30 | obj-$(CONFIG_I2C_ELEKTOR) += i2c-elektor.o |
||
| 31 | obj-$(CONFIG_I2C_MLXCPLD) += i2c-mlxcpld.o |