OpenWrt – Blame information for rev 3
?pathlinks?
Rev | Author | Line No. | Line |
---|---|---|---|
1 | office | 1 | /dts-v1/; |
2 | |||
3 | #include "rt3050.dtsi" |
||
4 | |||
5 | #include <dt-bindings/gpio/gpio.h> |
||
6 | #include <dt-bindings/input/input.h> |
||
7 | |||
8 | / { |
||
9 | compatible = "upvel,ur-336un", "ralink,rt3052-soc"; |
||
10 | model = "UPVEL UR-336UN"; |
||
11 | |||
12 | cfi@1f000000 { |
||
13 | compatible = "cfi-flash"; |
||
14 | reg = <0x1f000000 0x800000>; |
||
15 | bank-width = <2>; |
||
16 | device-width = <2>; |
||
3 | office | 17 | #address-cells = <1>; |
18 | #size-cells = <1>; |
||
1 | office | 19 | |
3 | office | 20 | partition@0 { |
21 | label = "u-boot"; |
||
22 | reg = <0x0 0x30000>; |
||
23 | read-only; |
||
24 | }; |
||
1 | office | 25 | |
3 | office | 26 | partition@30000 { |
27 | label = "u-boot-env"; |
||
28 | reg = <0x30000 0x10000>; |
||
29 | read-only; |
||
30 | }; |
||
1 | office | 31 | |
3 | office | 32 | factory: partition@40000 { |
33 | label = "factory"; |
||
34 | reg = <0x40000 0x10000>; |
||
35 | read-only; |
||
36 | }; |
||
1 | office | 37 | |
3 | office | 38 | partition@50000 { |
39 | label = "firmware"; |
||
40 | reg = <0x50000 0x7b0000>; |
||
1 | office | 41 | }; |
42 | }; |
||
43 | |||
3 | office | 44 | gpio-leds { |
1 | office | 45 | compatible = "gpio-leds"; |
46 | |||
47 | 3g { |
||
48 | label = "ur-336un:green:3g"; |
||
49 | gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
||
50 | }; |
||
51 | |||
52 | gateway { |
||
53 | label = "ur-336un:green:gateway"; |
||
54 | gpios = <&gpio0 11 GPIO_ACTIVE_LOW>; |
||
55 | }; |
||
56 | |||
57 | ap { |
||
58 | label = "ur-336un:green:ap"; |
||
59 | gpios = <&gpio0 12 GPIO_ACTIVE_LOW>; |
||
60 | }; |
||
61 | |||
3 | office | 62 | wps { |
1 | office | 63 | label = "ur-336un:green:wps"; |
64 | gpios = <&gpio0 14 GPIO_ACTIVE_LOW>; |
||
65 | }; |
||
66 | |||
67 | station { |
||
68 | label = "ur-336un:green:station"; |
||
69 | gpios = <&gpio0 13 GPIO_ACTIVE_LOW>; |
||
70 | }; |
||
71 | }; |
||
72 | |||
3 | office | 73 | gpio-keys-polled { |
1 | office | 74 | compatible = "gpio-keys-polled"; |
3 | office | 75 | #address-cells = <1>; |
76 | #size-cells = <0>; |
||
1 | office | 77 | poll-interval = <20>; |
78 | |||
79 | reset_wps { |
||
80 | label = "reset_wps"; |
||
81 | gpios = <&gpio0 10 GPIO_ACTIVE_LOW>; |
||
82 | linux,code = <KEY_RESTART>; |
||
83 | }; |
||
84 | |||
85 | mode { |
||
86 | label = "mode"; |
||
87 | gpios = <&gpio0 7 GPIO_ACTIVE_LOW>; |
||
88 | linux,code = <BTN_0>; |
||
89 | }; |
||
90 | }; |
||
91 | }; |
||
92 | |||
93 | &pinctrl { |
||
94 | state_default: pinctrl0 { |
||
95 | gpio { |
||
96 | ralink,group = "spi", "i2c", "jtag", "rgmii", "mdio", "uartf"; |
||
97 | ralink,function = "gpio"; |
||
98 | }; |
||
99 | }; |
||
100 | }; |
||
101 | |||
102 | ðernet { |
||
103 | mtd-mac-address = <&factory 0x4004>; |
||
104 | }; |
||
105 | |||
106 | &esw { |
||
107 | mediatek,portmap = <0x2f>; |
||
108 | }; |
||
109 | |||
110 | &wmac { |
||
111 | ralink,mtd-eeprom = <&factory 0>; |
||
112 | }; |
||
113 | |||
114 | &otg { |
||
115 | status = "okay"; |
||
116 | }; |