OpenWrt – Blame information for rev 3
?pathlinks?
Rev | Author | Line No. | Line |
---|---|---|---|
1 | office | 1 | /dts-v1/; |
2 | |||
3 | #include "rt3883.dtsi" |
||
4 | |||
5 | #include <dt-bindings/gpio/gpio.h> |
||
6 | #include <dt-bindings/input/input.h> |
||
7 | |||
8 | / { |
||
9 | compatible = "trendnet,tew-692gr", "ralink,rt3883-soc"; |
||
10 | model = "TRENDnet TEW-692GR"; |
||
11 | |||
12 | nor-flash@1c000000 { |
||
13 | compatible = "cfi-flash"; |
||
14 | reg = <0x1c000000 0x800000>; |
||
15 | bank-width = <2>; |
||
3 | office | 16 | #address-cells = <1>; |
17 | #size-cells = <1>; |
||
1 | office | 18 | |
3 | office | 19 | partition@0 { |
20 | reg = <0x0 0x0030000>; |
||
21 | label = "u-boot"; |
||
22 | read-only; |
||
23 | }; |
||
1 | office | 24 | |
3 | office | 25 | partition@30000 { |
26 | reg = <0x00030000 0x00010000>; |
||
27 | label = "u-boot-env"; |
||
28 | read-only; |
||
29 | }; |
||
1 | office | 30 | |
3 | office | 31 | factory: partition@40000 { |
32 | reg = <0x00040000 0x00010000>; |
||
33 | label = "factory"; |
||
34 | read-only; |
||
35 | }; |
||
1 | office | 36 | |
3 | office | 37 | partition@50000 { |
38 | reg = <0x00050000 0x007b0000>; |
||
39 | label = "firmware"; |
||
1 | office | 40 | }; |
41 | }; |
||
42 | |||
3 | office | 43 | gpio-keys-polled { |
1 | office | 44 | compatible = "gpio-keys-polled"; |
3 | office | 45 | #address-cells = <1>; |
46 | #size-cells = <0>; |
||
1 | office | 47 | poll-interval = <100>; |
48 | |||
49 | reset { |
||
50 | label = "reset"; |
||
51 | gpios = <&gpio0 10 GPIO_ACTIVE_LOW>; |
||
52 | linux,code = <KEY_RESTART>; |
||
53 | }; |
||
54 | |||
55 | wps { |
||
56 | label = "wps"; |
||
57 | gpios = <&gpio1 2 GPIO_ACTIVE_LOW>; |
||
58 | linux,code = <KEY_WPS_BUTTON>; |
||
59 | }; |
||
60 | }; |
||
61 | |||
3 | office | 62 | gpio-leds { |
1 | office | 63 | compatible = "gpio-leds"; |
64 | |||
65 | wps { |
||
66 | label = "tew-692gr:orange:wps"; |
||
67 | gpios = <&gpio0 9 GPIO_ACTIVE_LOW>; |
||
68 | }; |
||
69 | |||
3 | office | 70 | wps2 { |
1 | office | 71 | label = "tew-692gr:green:wps"; |
72 | gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; |
||
73 | }; |
||
74 | }; |
||
75 | }; |
||
76 | |||
77 | &gpio1 { |
||
78 | status = "okay"; |
||
79 | }; |
||
80 | |||
81 | &pinctrl { |
||
82 | state_default: pinctrl0 { |
||
83 | gpio { |
||
84 | ralink,group = "spi", "i2c", "jtag", "uartf"; |
||
85 | ralink,function = "gpio"; |
||
86 | }; |
||
87 | }; |
||
88 | }; |
||
89 | |||
90 | ðernet { |
||
91 | status = "okay"; |
||
92 | mtd-mac-address = <&factory 0x4>; |
||
93 | |||
94 | port@0 { |
||
95 | phy-handle = <&phy0>; |
||
96 | phy-mode = "rgmii"; |
||
97 | }; |
||
98 | |||
99 | mdio-bus { |
||
100 | status = "okay"; |
||
101 | |||
102 | phy0: ethernet-phy@0 { |
||
103 | reg = <0>; |
||
104 | phy-mode = "rgmii"; |
||
105 | |||
106 | qca,ar8327-initvals = < |
||
107 | 0x04 0x07600000 /* PORT0 PAD MODE CTRL */ |
||
108 | 0x0c 0x07600000 /* PORT6 PAD MODE CTRL */ |
||
109 | 0x10 0x40000000 /* Power-on Strapping: 176-pin interface configuration */ |
||
110 | 0x50 0xc437c437 /* LED Control Register 0 */ |
||
111 | 0x54 0xc337c337 /* LED Control Register 1 */ |
||
112 | 0x58 0x00000000 /* LED Control Register 2 */ |
||
113 | 0x5c 0x03ffff00 /* LED Control Register 3 */ |
||
114 | 0x7c 0x0000007e /* PORT0_STATUS */ |
||
115 | 0x94 0x0000007e /* PORT6 STATUS */ |
||
116 | >; |
||
117 | }; |
||
118 | }; |
||
119 | }; |
||
120 | |||
121 | &pci { |
||
122 | status = "okay"; |
||
3 | office | 123 | pinctrl-names = "default"; |
124 | pinctrl-0 = <&pci_pins>; |
||
1 | office | 125 | |
3 | office | 126 | pci_pins: pci { |
127 | pci { |
||
128 | ralink,group = "pci"; |
||
129 | ralink,function = "pci-fnc"; |
||
130 | }; |
||
131 | }; |
||
1 | office | 132 | |
3 | office | 133 | host-bridge { |
134 | pci-bridge@1 { |
||
135 | status = "okay"; |
||
136 | |||
137 | wifi@0,0 { |
||
138 | compatible = "pci0,0"; |
||
139 | reg = < 0x10000 0 0 0 0 >; |
||
140 | ralink,2ghz = <0>; |
||
141 | }; |
||
142 | }; |
||
1 | office | 143 | }; |
144 | }; |
||
145 | |||
146 | &wmac { |
||
147 | status = "okay"; |
||
148 | ralink,mtd-eeprom = <&factory 0x0>; |
||
149 | ralink,5ghz = <0>; |
||
150 | mtd-mac-address = <&factory 0x4>; |
||
151 | mtd-mac-address-increment = <3>; |
||
152 | }; |