OpenWrt – Blame information for rev 2
?pathlinks?
| Rev | Author | Line No. | Line |
|---|---|---|---|
| 1 | office | 1 | echo "CuBox OpenWrt Boot script" |
| 2 | |||
| 3 | # Set console variable for both UART and HDMI |
||
| 4 | setenv console console=ttymxc0,115200 video=mxcfb0:dev=hdmi,1920x1080M@60,if=RGB24,bpp=32 |
||
| 5 | |||
| 6 | # Find correct dtb |
||
| 7 | if test ${board_rev} = MX6DL; then |
||
| 8 | setenv fdt_soc_type imx6dl; |
||
| 9 | elif test ${board_rev} = MX6Q; then |
||
| 10 | setenv fdt_soc_type imx6q; |
||
| 11 | fi |
||
| 12 | if test ${board_name} = CUBOXI; then |
||
| 13 | setenv fdt_name ${fdt_soc_type}-cubox-i.dtb; |
||
| 14 | elif test ${board_name} = HUMMINGBOARD; then |
||
| 15 | setenv fdt_name ${fdt_soc_type}-hummingboard.dtb; |
||
| 16 | fi |
||
| 17 | |||
| 18 | # Set correct devtype and partition |
||
| 19 | if test ${devtype} != mmc; then setenv devtype mmc; fi |
||
| 20 | if mmc dev 0; then |
||
| 21 | setenv mmcdev 0 |
||
| 22 | elif mmc dev 1; then |
||
| 23 | setenv mmcdev 1 |
||
| 24 | fi |
||
| 25 | |||
| 26 | # Boot from the SD card is supported at the moment |
||
| 27 | setenv bootargs "${console} root=/dev/mmcblk1p2 rw rootwait" |
||
| 28 | mmc dev ${mmcdev} |
||
| 29 | load ${devtype} ${mmcdev}:${devplist} ${kernel_addr_r} /uImage |
||
| 30 | load ${devtype} ${mmcdev}:${devplist} ${fdt_addr_r} /${fdt_name} |
||
| 31 | bootz ${kernel_addr_r} - ${fdt_addr_r} |