OpenWrt – Blame information for rev 3
?pathlinks?
Rev | Author | Line No. | Line |
---|---|---|---|
1 | office | 1 | --- a/arch/mips/bcm63xx/boards/board_bcm963xx.c |
2 | +++ b/arch/mips/bcm63xx/boards/board_bcm963xx.c |
||
3 | @@ -426,6 +426,25 @@ static struct board_info __initdata boar |
||
4 | .force_duplex_full = 1, |
||
5 | }, |
||
6 | }; |
||
7 | + |
||
8 | +// Actually this board is the very same as the rta770bw, |
||
9 | +// where the additional 'b' within the name just |
||
10 | +// just indicates 'Annex B'. The ADSL Modem itself is able |
||
11 | +// to handle both Annex A as well as Annex B - |
||
12 | +// the loaded firmware makes the only difference |
||
13 | +static struct board_info __initdata board_rta770w = { |
||
14 | + .name = "RTA770W", |
||
15 | + .expected_cpu_id = 0x6345, |
||
16 | + |
||
17 | + .has_enet0 = 1, |
||
18 | + |
||
19 | + .enet0 = { |
||
20 | + .has_phy = 1, |
||
21 | + .phy_id = 0, |
||
22 | + .force_speed_100 = 1, |
||
23 | + .force_duplex_full = 1, |
||
24 | + }, |
||
25 | +}; |
||
26 | #endif /* CONFIG_BCM63XX_CPU_6345 */ |
||
27 | |||
28 | /* |
||
3 | office | 29 | @@ -1443,6 +1462,7 @@ static const struct board_info __initcon |
1 | office | 30 | #ifdef CONFIG_BCM63XX_CPU_6345 |
31 | &board_96345gw2, |
||
32 | &board_rta770bw, |
||
33 | + &board_rta770w, |
||
34 | #endif |
||
35 | #ifdef CONFIG_BCM63XX_CPU_6348 |
||
36 | &board_96348r, |
||
3 | office | 37 | @@ -1517,6 +1537,7 @@ static struct of_device_id const bcm963x |
1 | office | 38 | #ifdef CONFIG_BCM63XX_CPU_6345 |
39 | { .compatible = "brcm,bcm96345gw2", .data = &board_96345gw2, }, |
||
40 | { .compatible = "dynalink,rta770bw", .data = &board_rta770bw, }, |
||
41 | + { .compatible = "dynalink,rta770w", .data = &board_rta770w, }, |
||
42 | #endif |
||
43 | #ifdef CONFIG_BCM63XX_CPU_6348 |
||
44 | { .compatible = "belkin,f5d7633", .data = &board_96348gw_10, }, |