OpenWrt – Blame information for rev 2

Subversion Repositories:
Rev:
Rev Author Line No. Line
1 office 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
2 /dts-v1/;
3  
4 #include <dt-bindings/gpio/gpio.h>
5 #include <dt-bindings/input/input.h>
6  
7 #include "qca953x.dtsi"
8  
9 / {
10 compatible = "comfast,cf-e110n-v2", "qca,qca9533";
11 model = "COMFAST CF-E110N v2";
12  
13 aliases {
14 serial0 = &uart;
15 led-boot = &wan;
16 led-failsafe = &wan;
17 led-upgrade = &wan;
18 };
19  
20 leds {
21 compatible = "gpio-leds";
22  
23 pinctrl-names = "default";
24 pinctrl-0 = <&jtag_disable_pins &led_rssilow_pin &led_rssimediumhigh_pin &led_rssihigh_pin>;
25  
26 wan: wan {
27 label = "cf-e110n-v2:green:wan";
28 gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
29 };
30  
31 lan {
32 label = "cf-e110n-v2:green:lan";
33 gpios = <&gpio 2 GPIO_ACTIVE_LOW>;
34 };
35  
36 rssilow {
37 label = "cf-e110n-v2:red:rssilow";
38 gpios = <&gpio 11 GPIO_ACTIVE_LOW>;
39 };
40  
41 rssimediumlow {
42 label = "cf-e110n-v2:red:rssimediumlow";
43 gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
44 };
45  
46 rssimediumhigh {
47 label = "cf-e110n-v2:green:rssimediumhigh";
48 gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
49 };
50  
51 rssihigh {
52 label = "cf-e110n-v2:green:rssihigh";
53 gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
54 };
55 };
56  
57 ath9k-leds {
58 compatible = "gpio-leds";
59  
60 wlan {
61 label = "cf-e110n-v2:green:wlan";
62 gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
63 linux,default-trigger = "phy0tpt";
64 };
65 };
66  
67 keys {
68 compatible = "gpio-keys-polled";
69 poll-interval = <20>;
70  
71 reset {
72 label = "reset";
73 linux,code = <KEY_RESTART>;
74 gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
75 debounce-interval = <60>;
76 };
77 };
78 };
79  
80 &pinmux {
81 led_rssilow_pin: pinmux_rssilow_pin {
82 pinctrl-single,bits = <0x8 0x0 0xff000000>;
83 };
84  
85 led_rssimediumhigh_pin: pinmux_rssimediumhigh_pin {
86 pinctrl-single,bits = <0xc 0x0 0x00ff0000>;
87 };
88  
89 led_rssihigh_pin: pinmux_rssihigh_pin {
90 pinctrl-single,bits = <0x10 0x0 0x000000ff>;
91 };
92 };
93  
94 &spi {
95 status = "okay";
96 num-cs = <1>;
97  
98 flash@0 {
99 compatible = "winbond,w25q128", "jedec,spi-nor";
100 reg = <0>;
101 spi-max-frequency = <25000000>;
102  
103 partitions {
104 compatible = "fixed-partitions";
105 #address-cells = <1>;
106 #size-cells = <1>;
107  
108 partition@0 {
109 label = "u-boot";
110 reg = <0x000000 0x010000>;
111 read-only;
112 };
113  
114 art: partition@10000 {
115 label = "art";
116 reg = <0x010000 0x010000>;
117 read-only;
118 };
119  
120 partition@20000 {
121 compatible = "denx,uimage";
122 label = "firmware";
123 reg = <0x020000 0xfd0000>;
124 };
125  
126 partition@ff0000 {
127 label = "nvram";
128 reg = <0xff0000 0x010000>;
129 read-only;
130 };
131 };
132 };
133 };
134  
135 &uart {
136 status = "okay";
137 };
138  
139 &eth0 {
140 status = "okay";
141 mtd-mac-address = <&art 0x0>;
142 phy-handle = <&swphy4>;
143 };
144  
145 &eth1 {
146 status = "okay";
147 mtd-mac-address = <&art 0x1002>;
148  
149 gmac-config {
150 device = <&gmac>;
151 };
152 };
153  
154 &wmac {
155 status = "okay";
156 mtd-cal-data = <&art 0x1000>;
157 mtd-mac-address = <&art 0x6>;
158 };