OpenWrt – Blame information for rev 2

Subversion Repositories:
Rev:
Rev Author Line No. Line
1 office 1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
2 /dts-v1/;
3  
4 #include <dt-bindings/gpio/gpio.h>
5 #include <dt-bindings/input/input.h>
6  
7 #include "ar9341.dtsi"
8  
9 / {
10 model = "TP-Link TL-WR841N/ND v8";
11 compatible = "tplink,tl-wr841-v8", "qca,ar9341";
12  
13 aliases {
14 serial0 = &uart;
15 led-boot = &system;
16 led-failsafe = &system;
17 led-running = &system;
18 led-upgrade = &system;
19 };
20  
21 keys {
22 compatible = "gpio-keys-polled";
23 poll-interval = <20>;
24  
25 pinctrl-names = "default";
26 pinctrl-0 = <&jtag_disable_pins>;
27  
28 reset {
29 label = "Reset";
30 linux,code = <KEY_RESTART>;
31 gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
32 debounce-interval = <60>;
33 };
34  
35 rfkill {
36 label = "WiFi";
37 linux,code = <KEY_RFKILL>;
38 gpios = <&gpio 16 GPIO_ACTIVE_HIGH>;
39 debounce-interval = <60>;
40 };
41 };
42  
43 leds {
44 compatible = "gpio-leds";
45  
46 system: power {
47 label = "tp-link:green:power";
48 gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
49 default-state = "on";
50 };
51  
52 wlan {
53 label = "tp-link:green:wlan";
54 gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
55 linux,default-trigger = "phy0tpt";
56 };
57  
58 qss {
59 label = "tp-link:green:qss";
60 gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
61 };
62  
63 wan {
64 label = "tp-link:green:wan";
65 gpios = <&gpio 18 GPIO_ACTIVE_LOW>;
66 };
67  
68 lan1 {
69 label = "tp-link:green:lan1";
70 gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
71 };
72  
73 lan2 {
74 label = "tp-link:green:lan2";
75 gpios = <&gpio 20 GPIO_ACTIVE_LOW>;
76 };
77  
78 lan3 {
79 label = "tp-link:green:lan3";
80 gpios = <&gpio 21 GPIO_ACTIVE_LOW>;
81 };
82  
83 lan4 {
84 label = "tp-link:green:lan4";
85 gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
86 };
87 };
88 };
89  
90 &ref {
91 clock-frequency = <25000000>;
92 };
93  
94 &uart {
95 status = "okay";
96 };
97  
98 &gpio {
99 status = "okay";
100 };
101  
102 &spi {
103 num-cs = <1>;
104  
105 status = "okay";
106  
107 flash@0 {
108 compatible = "jedec,spi-nor";
109 reg = <0>;
110 spi-max-frequency = <25000000>;
111  
112 partitions {
113 compatible = "fixed-partitions";
114 #address-cells = <1>;
115 #size-cells = <1>;
116  
117 uboot: partition@0 {
118 label = "u-boot";
119 reg = <0x000000 0x020000>;
120 read-only;
121 };
122  
123 partition@20000 {
124 compatible = "tplink,firmware";
125 label = "firmware";
126 reg = <0x020000 0x3d0000>;
127 };
128  
129 art: partition@3f0000 {
130 label = "art";
131 reg = <0x3f0000 0x010000>;
132 read-only;
133 };
134 };
135 };
136 };
137  
138 &eth0 {
139 status = "okay";
140  
141 phy-handle = <&swphy0>;
142 mtd-mac-address = <&uboot 0x1fc00>;
143 mtd-mac-address-increment = <(-1)>;
144 };
145  
146 &eth1 {
147 status = "okay";
148  
149 mtd-mac-address = <&uboot 0x1fc00>;
150  
151 pll-data = <0x06000000 0x00000101 0x00001616>;
152  
153 gmac-config {
154 device = <&gmac>;
155 switch-phy-swap = <1>;
156 };
157 };
158  
159 &wmac {
160 status = "okay";
161  
162 mtd-cal-data = <&art 0x1000>;
163 mtd-mac-address = <&uboot 0x1fc00>;
164 };